Inhoudsopgave
Advertenties
RESTORING FACTORY SETTINGS
If the PIN code protection is disabled, the user, installer and expert settings
are re-initialized:
1- From the internal temperature monitoring setting, press
appears on the display.
NO
2-
fl ashes. Press
or
yes
= Factory settings reset
NO
= Factory settings not reset
3- Press the key
for 5 seconds. The device returns to its initial confi -
guration and goes back automatically to the Auto mode.
The following factory values will be eff ective:
Settings
Operation
Comfort setting temperature
Boost duration
Keypad lock
User settings
Backlighting
Eco mode temperature lowering-
level
Frost protection temperature
Super Comfort
Minimum set of Comfort setting
temperature
Maximum set of Comfort setting
temperature
Maximal Boost duration
rest
.
YES
to select
.
5 sec.
Factory settings
19°C
60 min.
Disabled
L3
-3,5°C
7°C
Enabled
7°C
30°C
60 min.
Settings
Maximum ambient temperature
for the automatic stop of the
Boost
Temperature unit
Installer settings
Automatic open window
detection
Occupancy detection
Dual optimization feature
PIN code protection
Value of the PIN code
Expert settings
Energy type
Power
Internal temperature monitoring
To exit the Expert settings, press
MAINTENANCE AND
CLEANING OF THE DUST
FILTER
Before any maintenance work, switch off the device by pressing the but-
ton (switch).
The device can be cleaned with a damp cloth; never use abrasives or
solvents.
• Maintenance and cleaning of the dust fi lter
The blower is equipped with a removable dust fi lter which retains
impurities from the air aspirated into the room.
When the fi lter is saturated, the dust accumulation may cause its stop.
FILT
In Boost mode, the writing
Before any action of fi lter removal, switch off the device by pressing the
button located under the blower.
EN
Factory settings
39°C
°C
Enabled
Enabled
Opti comfort
Disabled
0000
Elec
500W
90°C
3 times.
appears on the display.
M16MI328 A02_01/18
21
Advertenties
Hoofdstukken
Inhoudsopgave
