Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
i) Swash Plate Servo Setting „SWASH MIX"
In this menu, you can adjust the mixing ratio of the swash plate servos to each other. In this way you can perfectly
set the correct movement direction and the required angle of deflection or shift path of the swash plate in reaction to
the transmitter control signals.
Proceed as follows to set the swash plate servo:
• Call the function settings menu.
• Select the menu item „SWASH MIX" with the buttons „UP" or
„DOWN".
• Activate the menu item with the button „SELECT".
The display shows the set values of the three swash plate
servos and the linkage type „3 Servos 120".
If any other linkage type is displayed, the model helicopter
„HCP80" requires the corresponding setting in the system
setting menu, menu item of the model type selection (chapter
13 e). The triangle pointing to the right at the set value „AILE"
shows that the setting for the rolling function can be made.
• Pushing the buttons „INC (+)" or „DEC (-)" sets the lateral in-
clination of the swash plate for the rolling function. The higher
the set value, the higher the movement of the swash plate
when the control stick reaches its full deflection. By setting
a value with negative prefix, the movement directions of the
swash plate changes.
• Pushing the button „CLEAR" will call the set value specified
ex works again.
• The setting is saved automatically.
• Push the button „SELECT" to set the swash plate movement for the pitch function „PIT". The pitch value setting
(lifting and lowering of the swash plate) takes place according to the same principle as in the roll function.
• Push the button „SELECT" again to set the required swash plate movement in the nod function „ELEV" as well.
• Push the buttons „UP" and „DOWN" at the same time to return to the overview of the function setting menu.
108
All manuals and user guides at all-guides.com
Figure 44
Advertenties
Hoofdstukken
Inhoudsopgave
