Inhoudsopgave
Advertenties
Note 2: Should there be repeated false alerts when using the preset transmitter indi-
cation, this may hint at a neighbouring Signolux installation causing interference. In
this case, the problem can be solved by individually pairing all transmitter and recei-
ver units within the setup (see „Linking transmitter alerts with event icons").
Reset to factory defaults
Delete the pairing of each event icon (see „Deleting transmitters" ). When all previous-
ly assigned transmitters have been removed from the memory, the preset transmitter
indication is restored and the transmitters are automatically displayed again.
Linking transmitter alerts with event icons
Up to 8 transmitters (e.g. the doorbell push-button) can be assigned to each event
icon. This assignment can be adapted by pairing.
Please keep in mind that a transmitter can only be paired if it is not yet known in the
memory of the Lisa-Signolux receiver. If required, you might first have to delete the
transmitter from the memory.
a) Keep the function button »
in sequence. Release the button as soon as you see the desired icon.
b) Now trigger the signal using your transmitter (e.g. operate the doorbell pushbutton).
c) Wait for about 20 seconds and test the function.
Deleing transmitters
Do the following if you want to remove transmitter from the memory:
a) Keep the function button »
sequence. Let go of the button as soon as you see the desired icon.
b) Now press the function button »
briefly light up.
Please note that this will remove all assigned transmitters from the selected event
icon.
•
« (14) pressed for some time. The event icons light up
•
« pressed for some time. The event icons light up in
•
« and the melody button » « until all icons
English 23
Advertenties
Inhoudsopgave
