Inhoudsopgave
Advertenties
6.4 CONNECTING THE BATTERY CHARGER
Caution: Make sure that the charger is not connected to the power socket. Always connect the red positive cable
(+) of the charger (Position 9 in the overview) to the positive pole of the battery first. Then connect the black minus
cable (-) to the minus pole of the battery. If you charge the battery in situ, connect the black negative cable (-) to the
car body (exposed part), far away from the battery, the carburettor and fuel lines. Always maintain this sequence.
Caution: When the red control lamp (Position 5 in the overview) lights up, the charging cables have been connec-
ted incorrectly. Remove the pole callipers from the battery poles and connect them correctly.
6.5 CHARGING THE BATTERY
Now connect the mains connection cable (Position 8 in the overview) of the battery charger to the power socket. Now the green
control lamp „ON" (Position 4 in the overview) and the yellow control lamp „CHARGING" (Position 3 in the overview) light up.
The battery is being charged.
Once the battery is fully charged, the battery charger switches over to maintenance mode. The green „FULL" control lamp (Posi-
tion 2 in the overview) lights up.
6.6 REMOVING THE CHARGER
Caution: First pull the plug out of the socket and observe the sequence for disconnection. This prevents sparks
from forming. Since charging generates a detonating gas, this is particularly important for the sake of your safety.
Disconnect the charger from the mains power supply.
Then disconnect the black callipers (minus). Then remove the battery callipers from the plus pole of the battery (red callipers).
Allow the battery to cool down.
Only for open batteries: Fill the cells with distilled water up to the level specified by the battery manufacturer. Close the
battery cells with the stoppers.
7. MAINTENANCE AND CARE
7.1 MAINTENANCE
The battery charger is maintenance-free when used in accordance with the intended purpose.
7.2 CARE
Clean the pole callipers every time the charging procedure is completed. Remove all splashed battery acid from the pole callipers
to prevent corrosion. Clean the device carefully with a dry cloth. Do not use liquids or chemical cleaning agents. Never submerge
the device in liquid. Never allow liquid to flow over the device.
Properly roll up the cable onto the holders supplied before storing the device in order to prevent damage to the cables and the
device. Store the device in a dry and clean location.
8. NOTES REGARDING ENVIRONMENTAL PROTECTION
The packaging is made up of environmentally friendly materials which may be disposed of via your local recycling
points. Do not put electrical devices into the household waste. Electronic and electrical devices must be collected
separately and sent for environmentally friendly recycling. Contact your community or town administration for
information regarding the disposal of electrics.
9. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
10
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
Advertenties
Hoofdstukken
Inhoudsopgave
