Hilti TE 500 Originele Gebruiksaanwijzing pagina 23
Verberg thumbnails
Zie ook voor TE 500:
- Gebruikershandleiding (19 pagina's) ,
- Handleiding (23 pagina's)
Advertenties
Trouble or fault
Power tool does not start.
No hammering action.
The tool does not achieve
full power.
The accessory tool can't be
released.
Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled.
The materials must be correctly separated before they can be recycled. In many countries, your old
tools, machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.
▶
Do not dispose of power tools, electronic equipment or batteries as household waste!
RoHS (Restriction of Hazardous Substances)
The following links take you to the table of dangerous substances: qr.hilti.com/r7770034.
You will find a link to the RoHS table, in the form of a QR code, at the end of this document.
Further information
nl Originele gebruiksaanwijzing
Informatie over de handleiding
Bij deze handleiding
• Waarschuwing! Zorg, voordat u het product gebruikt, dat u de bij het product meegeleverde
handleiding incl. de aanwijzingen, veiligheidsinstructies en waarschuwingsaanwijzingen, afbeeldin-
gen en specificaties gelezen en begrepen hebt. Maakt u zich met name met alle aanwijzingen,
veiligheidsinstructies en waarschuwingsaanwijzingen, afbeeldingen, specificaties en bestanddelen
en functies vertrouwd. Als u dit niet doet, bestaat het risico op een elektrische schok, brand
*2227844*
Possible cause
Electrical fault.
The carbon brushes are worn
out.
The detachable supply cord is
not fitted correctly.
The tool is faulty or servicing is
due.
The power tool is too cold.
The gauge (cross section) of the
extension cord conductors is
inadequate.
The control switch is not fully
pressed.
The tool holder is not pulled
back fully.
2227844
Action to be taken
▶
Have the power tool and
supply cables checked by a
trained electrical specialist.
▶
Have the power tool checked
by a trained electrical special-
ist and the carbon brushes
replaced if necessary.
▶
Fit the detachable supply cord
to the power tool correctly.
▶
Have the product repaired
only by Hilti Service.
▶
Bring the tip of the accessory
tool into contact with the
workpiece and allow the
power tool to run under no load
until it reaches the minimum
operating temperature.
▶
Use an extension cord with
an adequate conductor cross
section.
▶
Press the control switch as far
as it will go.
▶
Pull the tool lock back as far
as it will go and remove the
accessory tool.
18
Advertenties
