Types of work
WARNING
Risk of electric shock! Severe injury and burns can result if any attempt is made to operate the tool
without an earth/ground conductor and ground fault circuit interrupter correctly connected.
▶
Irrespective of whether mains power or generator power is used, always make sure that an
earth/ground conductor and ground fault circuit interrupter are present in the power supply and
that these are correctly connected.
▶
Do not use the product unless these safety measures are in place and fully operational.
WARNING
A damaged supply cord presents a hazard! If the supply cord or extension cord is damaged while
work is in progress, immediately disconnect the device and the cord from the electricity supply. Do
not touch the damaged part of the cord.
▶
Regularly check all supply cords. Replace defective extension cords.
Full approval must be obtained from the site engineer or architect prior to beginning the work.
5
Chisel positioning
The chisel can be adjusted to 24 different positions (in 15° increments). This ensures that flat
chisels and shaped chisels can always be set to the optimum working position.
1.Push the accessory-tool release forward and hold it in this position.
2.Turn the accessory-tool release with the chisel to the desired position.
3.Let go of the accessory-tool release to lock the chisel in this position.
Chiseling
1.Slowly press the control switch.
Running speed can be controlled smoothly up to maximum by varying how far the control
switch is pressed.
2.To switch the power tool off, release the control switch.
Switching on and off in sustained operating mode
When chiseling, the control switch can be locked in the "on" position.
1.Press control switch 1 and then press control switch lock 2.
2.Release control switch 1 and then release control switch lock 2.
▶
The power tool then runs in sustained operating mode.
*2227844*
2227844
16