Inhoudsopgave
Advertenties
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Power supply of rechargeable battery: ... 18 V DC
Number of LEDs ............................................ 36
Light fl ux: ................................................ 1500 lm
Clamping width ................................ max. 40 mm
Weight: .....................................................0.46 kg
The tool can only to be used with the unit provi-
ded, especially the charger and battery packs,
other units may cause great danger!
5. Before starting the equipment
5.1 Fitting the battery (Fig. 2)
Press the pushlock button (b) of the battery as
shown in Fig. 2 and push the battery (a) into the
mount provided. Make sure that the pushlock
button engages properly! To remove the battery,
proceed in reverse order!
5.2 Charging the lithium battery pack
(Fig. 2/3)
1. Remove the battery pack (a) from the battery
mount, pressing the push/lock button (b)
downward to do so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
into the mains socket outlet. The green LED
will then begin to fl ash.
3. Push the battery pack onto the battery char-
ger.
In section "Charger indicator" you will fi nd a table
with an explanation of the LED indicator on the
charger.
5.3 Battery capacity indicator (Fig. 4)
Press the button for the battery capacity indicator
(e). The battery capacity indicator (d) shows the
charge status of the battery using 3 LEDs.
Anl_GC_OL_18_1500_Li_SPK10.indb 12
Anl_GC_OL_18_1500_Li_SPK10.indb 12
GB
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
If the battery pack fails to become charged, ple-
ase check
•
whether there is voltage at the socket-outlet
•
whether there is proper contact at the char-
ging contacts on the charger.
If the battery still fails to become charged, please
return
•
the charger
•
the battery pack
to our Customer Service Department.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
6. Before starting the equipment
6.1 On/Off switch (Fig. 5)
Switching on:
- 12 -
09.09.2024 07:54:19
09.09.2024 07:54:19
Advertenties
Inhoudsopgave
