3. Before you start the device
3.1 Device Installation
Remove all packaging material and all trans-
port bracing from the device.
For a safe and trouble-free running of the device,
choose the installation location which meets the
following requirements:
The floor should be firm, flat and horizontal.
Keep the following minimum clearances from
the device housing: 50 cm from its lateral side,
50 cm above, 50 cm from its rear side and
1 m from its front side.
Do not place the device in a hot and wet or
very humid environment or near combustible
material.
The socket should be easily accessible so that
the mains connection cable can be easily
disconnected, if necessary.
Temperature range: from 10 to +35 °C
Please note: When you use the device the first
time, a slight odour may occur.
3.2 Remote control: How to insert or change
the battery
The remote control unit is delivered together with
a lithium button cell
control, remove the plastic tape that protrudes
from the battery compartment
1
If the remote control battery needs to be re-
placed, insert a new 3-volt lithium button cell.
Pay attention to the type of lithium button cell
(CR2025).
12
GB/IE/NI/CY/MT
. To enable the remote
12
(see Figure 1).
10
Press the tab
on the battery compartment
11
of the remote control toward the centre. Now pull
out the battery compartment
2
12
11
Remove the old battery
Insert a new 3V-button-cell battery (type
CR2025). Pay attention to the correct polarity.
Push the battery compartment
remote control unit until the tab
place.
4. Starting Up
4.1 Standby mode
Plug the unit into a power outlet. Set the on/off
button 1 to the „ " position to supply power
to the unit. A short beep sounds.
The operation light
while the unit is in standby mode.
4.2 Switch on the unit
Press button 1 / A to switch on the product.
The appliance starts directly in appliance freeze
protection mode.
4.3 Switch off the unit
To return the unit to standby mode after
operation, press button 1 / A .
10
(see Figure 2).
10
10
.
12
back into the
10
snaps into
11
flashes on the display