Inhoudsopgave
Advertenties
Translation of the original instructions
stops completely. This feature prevents craters and cracks at the end of the weld.
Downslope activation (progressive arc reduction) :
DOWNSLOPE
Recommended combinations / electrode grinding
0,5-5
4-6
To optimise the welding process, it is recommended to grind the electrode prior to the welding, as described below:
L = 3 x d.
TROUBLESHOOTING
Troubleshooting
The machine does not deliver any
current and the yellow thermal
protection indicator is switched on
(6).
MMA-TIG
The product is connected to the
mains, you are feeling tingling
when touching the case.
The machine welds poorly.
When the machine starts, the
display shows
GYSMI E163
When the machine is in TIG LIFT mode:
• Press shortly the switch (5) to set the duration of the progressive arc
reduction.
• «dSt» (DOWNSLOPE) blinks and a number is displayed
(display (1)).
1 - 10 s / OFF
• Set from 1 to 10 seconds, with the possibility to desactivate it (OFF).
• Validate by pressing the switch (5).
• The machine is ready to operate.
Ø Electrode (mm)
Current (A)
(filler metal)
10-130
130-160
d
Causes
The thermal protection has swit-
The earth clamp, the electrode
holder or the welding torch are not
connected to the unit.
The earth contact is faulty.
The power supply voltage is not
suitable (230 V +/- 15%)
.
Ø Nozzle
= Ø wire
1,6
2,4
L
ched on.
Polarity error
Flow
(mm)
(Argon l/mn)
9,8
11
Solutions
Wait the end of the cooling cycle,
about 2 min. The indicator (6)
switches off.
Check the connections
Check the plug and the earth of
your installation.
Check the recommended polarity
(+/-) on the electrode box.
Check the power supply network
or the generator
EN
6-7
7-8
17
Advertenties
Inhoudsopgave
