NOTICE! Damage hazard
Do not place the device near heat sources (heaters, direct sunlight, gas ovens, etc.).
Set up the device in a dry location where it is protected against splashing water.
Use ductwork or cable ducts if it is necessary to lay cables through metal panels or other panels
with sharp edges.
Do not lay the cables so that it is loose or heavily kinked.
Do not pull on the cables.
Do not place the device near AGM or EFB batteries because they produce flammable, corrosive
and explosion gas while working.
Safety when handling batteries
WARNING! Risk of injury
Batteries contain aggressive and caustic acids. Avoid battery fluid coming into contact with
your body. If your skin does come into contact with battery fluid, wash that part of your body
thoroughly with water. If you sustain any injuries from acids, contact a doctor immediately.
When working on batteries, do not wear any metal objects such as watches or rings. Lead acid
batteries can cause short circuits which can cause serious injuries.
Only use insulated tools.
Do not place any metal parts on the battery.
Wear goggles and protective clothing when working on batteries. Do not touch your eyes
when working on batteries.
Do not use defective batteries.
WARNING! Health hazard
Keep the battery out of the reach of children.
CAUTION! Electrocution hazard
Keep the battery away from water.
Avoid short circuits.
Avoid clothing rubbing against the battery.
Wear antistatic clothing when handling the battery.
CAUTION! Explosion hazard
Do not place the battery in a area with flammable liquids or gases.
Never attempt to charge a frozen or defective battery. Place the battery in a frost-free area and
wait until the battery has acclimatised to the ambient temperature. Then start the charging
process.
Do not smoke, use an open flame, or cause sparking near the engine or a battery.
Keep the battery away from heat sources.
NOTICE! Damage hazard
Only use rechargeable batteries.
Prevent any metal parts from falling on the battery. This can cause sparks or short-circuit the
battery and other electrical parts.
Ensure that the polarity is correct when connecting the battery.
5