Advertenties
Safety Instructions
Electric shock, short
DANGER
circuit, fire, explosion
Use of a damaged or defective charger and a
damaged or defective electrical socket, improper use
of the charger or failure to observe the safety
instructions can cause short circuits, electric shocks,
explosions, fires or burns.
e Only use accessories, e.g. power supply and
vehicle cables, that have been approved and
supplied by Porsche.
e Do not use a damaged and/or soiled charger.
Check the cable and plug connection for damage
and soiling before use.
e Only connect the charger to properly installed and
undamaged electrical sockets and fault-free
electrical installations.
e Do not use extension cables, cable reels, multiple
sockets or (travel) adapters.
e Disconnect the charger from the mains supply
during thunder storms.
e Do not modify or repair any of the electrical
components.
e Only get experts to correct faults and carry out
repairs on the charger.
Electric shock, fire
DANGER
Incorrectly installed electrical sockets can cause
electric shock or fire when the high-voltage battery is
charged using the vehicle charge port.
e Power supply testing and installation and initial
operation of the electrical socket for the charger
must only be carried out by a qualified electrician.
The qualified electrician is fully responsible for
compliance with the relevant standards and
regulations. Porsche recommends that you use a
certified Porsche service partner.
e The cross-section of the power cable for the
electrical socket must be defined in accordance
with the wire length and the locally applicable
regulations and standards.
e The electrical socket used for charging must be
connected to a separately fused electric circuit
that complies with local laws and standards.
e The charger is intended for use in private and
semi-public areas, e.g. private properties or
company car parks. In some countries, e.g. in Italy
1)
and New Zealand
, mode 2 charging is
prohibited in public areas.
e Unauthorised persons (e.g. playing children) or
animals must not have access to the charger and
the vehicle during unsupervised charging.
e Always read the safety instructions in the
Installation Instructions and the Driver's Manual.
1) Time of printing. Further information is available from
your Porsche partner or from your local power supplier.
Safety Instructions
Electric shock, fire
DANGER
Incorrect handling of the plug contacts can lead to
electric shock or fire.
e Do not touch the contacts on the vehicle charge
port and charger.
e Do not insert any objects into the vehicle charge
port or charger.
e Protect electrical sockets and plug connections
against moisture, water and other liquids.
Flammable or explosive
WARNING
vapours
Components of the charger can cause sparks and
ignite flammable or explosive vapours.
e To reduce the risk of explosion – particularly in
garages – make sure that the control unit is
located at least 50 cm above the floor during
charging.
e Do not install the charger in potentially explosive
areas.
Observe the following instructions and
recommendations in order to guarantee
uninterrupted charging with the charger:
– When installing the electrical socket, select an
industrial electrical outlet with the highest
possible power available (adapted to the
domestic electrical installation) and have it
commissioned by a qualified electrician. Porsche
recommends that you use a certified Porsche
service partner.
– Where technically possible and legally
permissible, the electric installation must be
dimensioned in such a way that the maximum
nominal power of the electrical socket used is
available for charging the vehicle.
DE
EN
FR
IT
ES
PT
NL
SV
FI
DA
NO
EL
CZ
HU
PL
HR
SR
SK
SL
ET
LT
LV
RO
BG
MK
23
Advertenties
