Safety Information; Symbols/Warnings; Symbols Used On The Workstation Frame; Organizational Measures - Actiforce ALUFORCE PRO 150 M Montagehandleiding
Verberg thumbnails
Zie ook voor ALUFORCE PRO 150 M:
- Montagehandleiding (22 pagina's) ,
- Montagehandleiding (25 pagina's)
Inhoudsopgave
Advertenties
2 Safety Information
2.1 Symbols/Warnings
The assembly/operating manual uses the following terms and signs to indicate dangers:
This symbol indicates an immediate threatening situation for any person's life or
health. Failure to adhere to such information may have serious consequences
for health, or could even result in life-threatening injury or death.
This symbol indicates important information. Failure to adhere to such information
could lead to damage to the workstation.
2.2 Symbols used on the workstation frame
Do not place objects or parts of the body under the workstation frame or be-
tween the cross members. This could cause serious injury.
Do not exceed the maximum permitted load on the workstation frame. Overload-
ing could lead to breakage and serious injury as a consequence.
2.3 Organizational measures
•
The workstation frame can best be assembled by two people. Turning the frame, once
the work surface has been fitted, is a task in particular which requires two people!
2.4 Informal safety measures
•
Keep the assembly/operating manual in the place where the workstation frame is used
at all times.
•
Make sure that all safety information on the table (see Section 2.2, Symbols used on the
workstation frame, page 5) is legible, replacing the same if necessary.
2.5 Note for those assembling the workstation
•
The workstation must be assembled/worked on by persons over the age of 16.
•
The persons referred to above must have read and understood the assembly/operating
manual.
2.6 Transport and assembly
•
The workstation frame must only be moved when it is disconnected from mains electrici-
ty (i.e. when the plug has been removed from the socket).
•
The workstation frame must be moved by two persons only, and in such cases must be
retracted.
Do not drag or pull the workstation frame over the floor.
•
•
Assemble the workstation frame with the supplied tools only. They are the only tools
which ensure that the screws can be tightened to the correct torque.
2.7 Safety/protective measures
•
Replace the drives if the circuit breaker in the drives fails. Faulty circuit breakers will not
switch off the drive in the top/bottom setting. In such cases, the workstation frame has
been taken to the mechanical stop and can no longer be raised/lowered.
5
Advertenties
Hoofdstukken
Inhoudsopgave
