Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5.2
Tank straps
Depending on the models, SCUBAPRO BCs feature one of the following tank fastening systems
(see complete manual on www.scubapro.com):
• Super Cinch Q.A. (quick adjustment) strap.
• Standard Cinch.
• Quick Cinch
• Additional tank strap (some models).
• Quick-fastening system for two-tank set (some models).
! WARNING
To prevent accidental loss of the tank, ensure the strap is done up tightly enough so that
the tank cannot move or slide on the BC.
Failure to do so could result in injury or death.
! WARNING
Soak the webbing of the SCUBA air tank strap and then tighten prior to each use of the
BC. Webbing may stretch when initially exposed to water. Failure to soak the webbing
may allow the tank strap to loosen around the SCUBA air tank.
! WARNING
Check the correct positioning and the correct tightening of the tank straps before starting to dive.
! WARNING
Check the label sewn into your BC (or the complete manual at www.scubapro.com) for
the maximum tank size that can be used with your model and your size.
6. VALVE SET UP
6.1
Inflation
The BC can be inflated:
• by using the inflator valve (the BPI/AIR 2)
• by mouth (through the BPI/AIR 2)
! WARNING
AIR2 uses a dedicated quick disconnect coupling.
When using AIR2 be sure to use only the SCUBAPRO dedicated hose supplied with the
specific quick disconnect coupling.
6.2
Deflation
The BC can be deflated:
• using the manual dump valve (see Manual dump valve manual)
• using the mouthpiece (BPI and/or AIR 2)
• through the manual purge valve on the shoulder
• through the lower manual purge valve
• through the automatic purge valve
4
16791-00-Scubapro_jacket_readfirst-totale.indb 4
16791-00-Scubapro_jacket_readfirst-totale.indb 4
03/08/2020 09:44:24
03/08/2020 09:44:24
Advertenties
Inhoudsopgave
