4. IMPORTANT CAUTIONS
For your protection while using SCUBAPRO life support equipment, we call your attention to the
following:
1. Use the equipment according to the instructions contained in this manual and only after having
completely read and understood all instructions and warnings.
2. Use of the equipment is limited to the uses described in this manual or for applications approved
in writing by SCUBAPRO.
3. Tanks must only be filled with atmospheric compressed air, according to the EN 12021 norm.
Should moisture be present in the tank, beside causing corrosion of the tank, it may cause
freezing and subsequent malfunction of the regulator during dives carried out in low temperature
conditions (lower than 10°C (50°F)). Tanks must be transported according to local rules provided
for the transport of dangerous goods. Tank use is subjected to the laws regulating the use of
gases and compressed air.
4. Equipment must be serviced by qualified personnel at the prescribed intervals. Overhauls must
be documented. When making repairs and during maintenance, only SCUBAPRO replacement
parts must be used.
5. Should the equipment be serviced or repaired without complying with procedures approved
by SCUBAPRO or by untrained personnel or not certified by SCUBAPRO, or should it be used
in ways and for purposes other than specifically designated, liability for the correct and safe
function of the equipment transfers to the owner/user.
6. The content of this manual is based upon the latest information available at the time of going to
print. SCUBAPRO reserves the right to make changes at any time.
7. All dives must be planned and carried out so that at the end of the dive the diver will still have a
reasonable reserve of air for emergency use. The suggested amount is usually 50 bars (725 psi).
SCUBAPRO refuses all responsibility for damages caused by non-compliance with the instructions
contained in this manual. These instructions do not extend the warranty or the responsibilities
stated by SCUBAPRO terms of sales and delivery.
4.1
Disinfection
SCUBAPRO recommends McNett Revivex. Use according to the procedure and dilution described
on its packaging.
4.2
Inspection and Service Interval
Your BC should be inspected and maintained at an Authorized Service Center at least once a year,
more often if you dive frequently. Any damage caused due to failure to properly maintain the BC is
not covered by the warranty.
! WARNING
Always perform a pre-dive and post-dive inspection of the BC.
5. INITIAL SET UP
5.1
Low pressure hose (LP)
! WARNING
Do not attach a L.P. hose to a Scuba regulator high pressure (HP) port or to an air supply
with pressure in excess of 200 psi (13.8 bar). This may result in damage or explosive
failure of the Inflation Valve or Low pressure Hose, which could result in injury or death.
16791-00-Scubapro_jacket_readfirst-totale.indb 3
16791-00-Scubapro_jacket_readfirst-totale.indb 3
3
03/08/2020 09:44:24
03/08/2020 09:44:24