Do not use outdoors.
Always attach plug to appliance first, then plug cord in the wall outlet. To disconnect, turn
any control to "off", then remove the plug from wall outlet.
The use of any accessory attachment, not recommended by the appliance manufacturer,
may result in fire, electric shock or injury to persons.
Never fill the kettle with water when it is positioned on the base unit.
Never fill the kettle above the "MAX" mark (4). If the kettle is overfilled, boiling water may
be ejected.
Do not let cord hang over edge of table or counter, or touch hot surfaces.
Unplug the power cord from the wall outlet when the kettle is not in use and before clean-
ing. Allow the kettle to cool before putting on or taking off parts, and cleaning it.
Do not operate any appliance with a damaged cord or plug or after the appliance mal-
functions, or has been damaged in any manner. Return appliance to the nearest autho-
rized service facility for examination, repair or adjustment.
Never attempt to exchange the mains cable of the appliance as special tools are required
for this. To ensure continued safety of the appliance, if the cable needs to be repaired or
exchanged, have this carried out exclusively by a customer service workshop authorised
by the manufacturer.
To protect against fire, electric shock and injury to persons do not immerse cord, plug,
kettle container and power base in water or other liquid.
Scalding may occur if the lid is removed during the brewing cycles.
Make sure the lid is always closed when boiling.
Avoid spillage on the connector.
Misuse may cause potential injury.
The heating element surface is subject to residual heat after use.
SAVE THESE INSTRUCTIONS.
FOR HOUSEHOLD USE ONLY.
Place the appliance on a stable flat surface which is neither hot nor
INSTALLATION
near a heat source. The surface must be dry. Keep the appliance
and its mains cable out of reach of children.
Ensure that the voltage indicated on the rating plate of the appliance
agrees with the mains voltage in your area. Connect the appliance
only to a properly earthed power point with a minimum output of 12.5A.
(Use a residual current device (RCD) seek the advice of an electrician.)
While the appliance is in use, the mains plug must be accessible in
7
EN