Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
this, you can also use the directional buttons
(+
=
) on the remote control.
26 a
Press the Set schedule button on the robot vacuum
cleaner
or on the remote control
12
The first two digits in the display
Using the Return mode
buttons on the robot vacuum cleaner, set the
desired time in hours (01–23). To do this,
you can also use the directional buttons
(+
=
) on the remote control.
26 a
Finally, press the CLEAN button on the robot
vacuum cleaner
11
to confirm your selections.
After the set time has expired, the product will turn
itself on automatically and begin cleaning.
Note: If you turn the product off using the power
switch
, the saved settings will be lost.
9
Cleaning and storage
Set the power switch
cleaning the product.
Unplug the mains lead
socket before cleaning the product.
Do not rinse the product directly with water.
Do not wipe the product with a cloth soaked
in water.
Disconnect the power supply if the product will
not be used for an extended period.
Cleaning the dust collector
Open the product by pressing on the cover
where it says PUSH.
Remove the dust collector
pushing the cover
22
Remove the main filter
collector
.
21
Fold the dust collector cover
remove the filter frame
HEPA filter
from the outside of the dust
5
collector
.
21
Rinse the dust collector
under running water or clean them using a
24
damp cloth. Then wipe the dust collector
the filter frame
24
28 GB/IE
again.
30
will flash.
1
and Spot mode
13
26
or on the remote control
to position "O" before
9
from the mains
4
and open it by
21
upwards.
and empty the dust
23
forwards and
22
together with the
24
and the filter frame
21
21
until they are dry.
Clean the recess in the robot vacuum cleaner
26
for the dust collector using a dry cloth.
Clean the main filter
with the cleaning brush
filters when they are dry.
First, insert the HEPA filter
14
frame
, then insert into the dust collector
24
Close the cover of the dust collector
sure that it audibly clicks into place, and insert
the dust collector
Close the cover
it audibly clicks into place.
27
Cleaning the brushes
Regularly remove any hair and dirt from the
side brushes
Cleaning the main housing
Clean the 3 anti-fall sensors
their sensitivity.
Clean the front wheel
tangled in it.
Clean the anti-collision sensor
its sensitivity.
Replacing parts
Replacing the side brushes
If the side brushes
placed with the supplied replacement side brushes
Loosen the old side brushes
10
underside using a cross-tip screwdriver (not
included in the delivery contents).
Screw the replacement side brushes
place.
Replacing the HEPA filter
Depending on the frequency of use, the HEPA filter
should be cleaned after approx. 15 to 30 days.
5
After approx. 6 months it should be replaced with
and
the supplied replacement filter.
and the HEPA filter
23
. Only reinstall the
7
back into the filter
5
22
back into the product.
21
of the product, making sure
10
.
17
to maintain
18
to remove any hair
19
to maintain
20
are worn out, they can be re-
17
fixed to the
17
5
.
21
, making
.
6
into
6
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
