Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Inserting / replacing batteries
Open the battery compartment cover on the
remote control.
Insert two batteries into the battery compartment
or replace the old batteries with new ones.
Only use batteries of the specified type (see
"Technical data").
Note: When inserting the batteries, be sure to
observe the correct polarity. This is shown in the
battery compartment.
Close the battery compartment cover on the
remote control.
Operation
Due to the complexity of domestic environments the
product may skip some areas when cleaning. For
better cleaning results we recommend using the
product daily.
Preparation
Remove any obstacles prior to use, for example
power cables, toys and other objects.
Tuck rug edges under the rug. Do not allow
curtains and tablecloths to touch the floor.
Try to position furniture properly.
Test the product in areas with stairs. This allows
you to check whether the product can detect
the edge of area which it could fall off.
Do not stand in the way of the product when it
is working. Otherwise the product will be unable
to clean these areas.
Cleaning
Cleaning modes
For better cleaning results, the product has various
cleaning modes. You can select the modes by press-
ing the buttons on the product or on the remote
control.
26 GB/IE
Auto mode
Press the CLEAN button on the robot vacuum
cleaner
or on the remote control
11
display shows "88:88". The notification will
switch to AUTO and the product will begin the
cleaning programme. If the product is in Standby
Mode, the initial "88:88" notification will ap-
pear after the CLEAN button is pressed for the
first time. When the CLEAN button is pressed
for a second time, the notification switches to
AUTO and the cleaning programme begins.
In Auto mode, the robot vacuum cleaner cleans
until the battery power has run out. The robot
vacuum cleaner will then return to the charging
dock
.
2
Note: During automatic cleaning, the product
will switch to Corner mode when necessary, if
it is nearing a corner. After cleaning the corner,
the product will switch back to Normal mode.
To pause the cleaning programme part way
through, press the CLEAN button on the robot
vacuum cleaner
11
To continue the cleaning programme, press the
CLEAN button on the robot vacuum cleaner
or on the remote control
seconds. If the pause lasts longer than 30 sec-
onds, the product will switch to Sleep mode and
the notification in the display
If the robot vacuum cleaner is approx. 30 cm
from the charging dock
automatically return to the charging dock
You can also switch the product to Sleep mode
manually. To do so, hold down the CLEAN but-
ton on the robot vacuum cleaner
seconds until the notification in the display
disappears.
With the product paused, you can use the direc-
tional buttons
on the remote control to man-
26
ually move it left / right / forwards / backwards.
Spot mode
This mode is suitable for very dirty or very dusty
areas. In Spot mode, the product will focus on one
area to clean and will clean with maximum suction
power. The maximum radius in Spot mode is 45 cm.
if the
27
or on the remote control
again within 30
27
will go off.
1
in this situation, it will
2
2
for a few
11
.
27
11
.
1
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
