Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Settings / Maintenance and Cleaning / Disposal
Configuring the detection
range
You can configure the detection range of the
motion sensor in 5 stages using the DIP switch
10 %
25 %
50 %
75 %
100 %
1 2 3
Ⅰ
ON ON ON
100%
ON
Ⅱ
ON ON
75%
Ⅲ
50%
ON
ON
Ⅳ
25%
ON
Ⅴ
10%
Configuring the lighting
duration
You can use the DIP switch
lighting duration of the sensor ceiling light
in 6 stages.
Note: The lighting duration refers to the dura-
tion of the sensor ceiling light
mination after motion has been detected.
4 5 6
Ⅰ
ON ON ON
5s
ON
Ⅱ
ON ON
30s
Ⅲ
ON
ON
90s
Ⅳ
ON
3min
Ⅴ
ON ON
20min
Ⅳ
30min
Configuring ambient
brightness
You can use the DIP switch
sensor in 5 stages so that the sensor ceiling
light
only illuminates at a determined ambi-
1
ent brightness threshold.
10 GB/IE/NI
5
approx. 1.2 m
approx. 3 m
approx. 6 m
approx. 9 m
approx. 12 m
to configure the
5
1
at 100 % illu-
1
to configure the
5
If you select the setting "disable" (deactivated)
the daylight sensor of the sensor ceiling light
will switch if motion has been detected, irre-
1
spective of the ambient light (50 lux, 30 lux:
.
dusk operation, 10 lux, 2 lux: night operation).
7 8 9
Ⅰ
ON ON ON
2lux
ON
Ⅱ
ON ON
10lux
Ⅲ
ON
30lux
Ⅳ
ON
50lux
Ⅴ
Disable
Maintenance and Cleaning
CAUTION! DANGER OF ELECTRIC
SHOCK! Disconnect the light from the power
supply before cleaning. To do so, remove the
fuse or switch off the circuit breaker in the fuse
box (0 setting).
Do not use solvents, petrol, etc. They could
damage the light.
Allow the light to cool down completely.
CAUTION! DANGER OF ELECTRIC
SHOCK! For electrical safety, never clean the
light with water or other liquids, nor immerse it
in water.
Only clean with a dry, lint-free cloth.
Then replace the fuse or switch on the circuit
breaker in the fuse box (I setting).
Disposal
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities. The Green
Dot is not valid for Germany.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
Advertenties
Hoofdstukken
Inhoudsopgave
