Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
MAINTENANCE
Cleaning the grid and grease filter
1. Remove the grid from the extraction inlet.
2. Carefully pull the grease filter out of the extraction inlet.
•
Clean the grid with hot water and neutral soap, without using abrasive sponges (do not use
detergents!). Do not wash the cast iron grid in a dishwasher.
•
Clean the grease filter at least every 2 months (or when the filter saturation indication
system indicates this necessity. This will maintain good performance of the extractor and
prevent a potential fire hazard, caused by excessive grease build-up.
•
Clean the filter with a non-aggressive detergent, preferably by hand, or in the dishwasher,
which must be set to a low temperature and a short cycle.
Odour filter (recirculation use)
If you use a filter unit installed in the kitchen plinth: replace the odour filter, depending on the
intensity of use, every year (or when the saturation indicator indicates this). To do this, order
replacement filter HF3009. When inserting the new filter, pay attention to the arrow that indicates
the direction of the airflow.
Attention: please note that these filters are not regenerable and should be disposed of
with residual waste after use.
(external recirculation filters)
EN 33
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
