Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
device checked by an authorized specialist dealer.
• Use this product only for the purpose described in the
instructions for use.
• Operate the device only with the specified voltage
(230 V/50 Hz).
• The unit should not be covered => Risk of overheating!
• Connect the device only to the mattress intended for it.
• This device is safeguarded against electrical shock
according to the specifications for type BF devices!
Product protection class I
• Do not allow the system to come into contact with
sharp objects (knives, scissors, cannulas, etc.).
• This device should not be disposed of with household
waste. More information is available from local waste
management companies.
• When using side rails on adjustable beds for disabled
persons, a sufficient distance between the top edge
of the positioning system and the upper end of the
bed rail must be ensured. (220 mm according to DIN
1970:2000). If necessary, corresponding side rail risers
should/must be attached to protect the patient.
• Every serious incident which occurs in connec-
tion with the product must be reported to the manu-
facturer and the competent authority of the mem-
ber state in which the user and/or patient is located.
EMC
This product meets the protection requirements listed in
the council directive on the approximation of the laws
of the member states on electromagnetic compatibility
(EMC, IEC 60601-1-2).
However, mutual interference between electrical de-
vices, particularly when mobile telephones are used,
cannot be completely ruled out under certain conditions.
Setting up the system
The Med Aire FlexWave replaces the existing mattress in
your standard or hospital bed.
It does not impair the functionality of the standard or
hospital bed.
• Take the Med Aire FlexWave out of the packaging.
• Check the contents for completeness and any visible
damage.
14
Drive Medical GmbH & Co. KG | As per: 28.07.2023 | Errors and alterations excepted
• Now remove the existing mattress from the standard
or hospital bed if you have not already done so.
• Place the mattress replacement system in the existing
standard or hospital bed. The foot end is marked with
2 feet.
• Secure the mattress replacement system using the
available straps to the movable parts of the slatted
frame to avoid impairing the functionality of the system
and the adjustable slatted frame.
• Place the unit using the hooks provided at the foot
end, on the floor, or on an even surface.
Now attach the connection hose to the unit (photo 2).
Important! The connection hose must audibly click into
place in order to prevent an unintentional separation bet-
ween the unit and the mattress! Kinking or twisting the
connection hose must be avoided.
Now the Med Aire FlexWave is ready for use.
Instructions for use FLEX WAVE
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
