Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
01_TFA_No. 35.1156_Anl_08_24
16.08.2024
METEOTIME PRIMO – Weather Info Center
12. Alarm functions
• There are three different alarm functions:
Weekday alarm (W-ALM):
• This is a repeat alarm that will be activated daily from Monday to Friday at a set time.
Single alarm (S-ALM):
• This is a single alarm that will be activated once at a set time.
Pre-alarm (P-ALM):
• Earlier wake-up time in case of frost.
12.1 Setting of the alarms
• Press the SET button to toggle between weekday alarm (W-ALM), single alarm (S-ALM) or pre-alarm (P-ALM).
OFF
•
appears on the display of each alarm when the alarm is turned off..
12.1.1 Weekday alarm (W-ALM) and Single alarm (S-ALM)
• Press the SET button to set the weekday alarm (W-ALM) or the single alarm (S-ALM).
• Press and hold the SET button for 3 seconds and the hour digits flash.
• Press the + or – button to set the hours.
• Press SET button to confirm and the minutes digits flash.
• Press the + or – button to set the minutes.
• Press the SET button to exit and the respective alarm symbols
12.1.2 Pre-Alarm – (alarm for frost alert = outdoor temperature at transmitter 1 ≤ 2°C)
• If the weekday (W-ALM) or the single day (S-ALM) alarm is set and an outdoor transmitter is installed on channel
1, the pre-alarm (P-ALM) can be programmed.
• Press several times the SET button, to enter the the frost alert setting mode P-ALM.
• Press and hold the SET button for 3 seconds.
• The number 15 will be flashing, meaning that if selected, the alarm will sound 15 minutes earlier than the weekday
or single alarm.
• Select the frost alert interval in 15 minutes increments between 15 and 90 minutes by using the + or – button.
• Press the SET button to exit and the alarm symbol
30
10:48 Uhr
Seite 16
or
will be activated.
will be activated.
METEOTIME PRIMO – Weather Info Center
12.2 Activate and deactivate the alarms
• When an alarm sounds, the respective alarm icons
for 5 seconds.
• Press the SNOOZE/LIGHT button to activate the snooze function.
• The alarm is interrupted for 5 minutes.
• Press + or – to stop the alarm immediately.
• If no button is pressed, the increasing alarm will sound for 2 minutes.
• Press the SET button in normal mode to toggle between the weekday alarm (W-ALM), single alarm (S-ALM) or
pre-alarm (P-ALM).
• To turn off the alarm, press the – button to change the alarm time display to
• Press the + button to activate the alarm function again. 00:00 or the last adjusted alarm time appears.
13. Backlight
• Press the SNOOZE/LIGHT button. The backlight turns on for 5 seconds.
14. Care and maintenance
• Clean the devices with a soft damp cloth. Do not use solvents or scouring agents.
• Remove the batteries from all devices if you do not use the weather station for a long period of time.
• Store the devices in a dry place.
14.1 Battery replacement
• Change the base station batteries, when the battery symbol appears on the display of the indoor temperature.
• Change the batteries of the outdoor transmitter, when the battery symbol appears on the display of the outdoor
temperature or on the transmitter.
• Open the battery compartments and insert the new batteries. Make sure the polarities are correct. Close the cov-
ers again.
• Please note:
When the batteries are changed, the contact between the transmitter and the base station must be restored – so
always insert new batteries into both devices or start a manual transmitter search.
,
or
will be flashing. The backlight turns on
OFF
.
31
Advertenties
Inhoudsopgave
