Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2. Shake the components vigorously in the water for at least one minute
and hand wash with a soft bristle brush. Pay particular attention to all
connection areas, elbow vent holes and valves.
3. Thoroughly rinse the components under running water.
4. Squeeze the headgear to remove excess water. Leave the
components to air dry out of direct sunlight.
If the mask components are not visibly clean, repeat the cleaning steps.
Reassembling your mask
1. With the ResMed logo facing outwards and up, insert the upper
headgear straps into the frame from the inside and fold the fastening
tabs over to secure.
2. Hold the top and bottom of the cushion and attach to the frame.
3. Attach the elbow to the frame.
WARNING
•
The mask must be used under qualified supervision for patients
who are unable to remove the mask by themselves. This mask is
not for use on patients with impaired laryngeal reflexes or other
conditions predisposing to aspiration in the event of regurgitation
or vomiting.
•
To avoid affecting the safety and quality of therapy, the mask
vents must be kept clear to protect against rebreathing. Regularly
inspect the vents to ensure they are kept clean, undamaged and
clear of blockages.
•
The mask contains specific safety features with the supplied
elbow (containing the valve and vent assembly) to ensure safe
and functional usage. Do not use the mask if these features are
damaged or missing.
•
The mask should not be used unless the device is turned on. Once
the mask is fitted, ensure the device is blowing air to reduce risk
of rebreathing exhaled air.
•
Oxygen supports combustion and must only be used in well
ventilated rooms. Do not use oxygen while smoking or near an
open flame. Oxygen flow must be turned off when the device is
not operating.
•
At a fixed rate of supplemental oxygen flow, the inhaled oxygen
English
5
Advertenties
Inhoudsopgave
