Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Replacing the table insert
Immediately replace a worn or damaged table insert.
Loosen the screws of the table insert (9) and remove them.
Insert a new table insert and screw it tightly in place.
Transport
Remove mains plug before each transport.
Before each transport
Position saw head vertically
Turn rotary table to 0°
Push saw head down and engage the transport locking
pin (5)
Remove the support arms (18) and the vise assembly
(19)
Secure the pulling device.
Carry the saw on its transport handle (2).
Always carry the saw on the carrying handle (2) or on
the outer cast parts. Do not hold the saw on the pro-
tective covers or handle (1) when lifting it.
Possible faults
Before each fault elimination:
Switch off device.
Wait for standstill of the saw blade
Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault code
Machine does not start after
switching on
No crosscut function
Machine stops while cutting Saw blade is dull
Saw blade jams while cut-
ting
Burned spots at the cut
areas
Saw vibrates
Chip outlet is clogged
Rotary table moves hard
Possible Cause
Power failure
Extension cable defective.
Motor or switch defect
Transport locking pin not removed
Feed is too great
Saw blade is dull
Saw blade is not suitable for the
work step or is dull
Saw blade is warped
Saw blade not properly mounted
No exhaust system connected
Exhaust power too weak
Chips under rotary table
Storage
Pull out power plug
Store unused equipment in a dry, locked place out of the
reach of children.
Before extended storage, please observe the following to
increase the service life of the device and to ensure smooth
operation:
Thoroughly clean the device.
treat all movable parts with an environmentally friendly oil
Never use any grease!
Guarantee
Please observe the enclosed terms of guarantee.
Remedy
Check the fuse.
Check cables, do not go on using defect cables
Have motor or switch checked by an approved electrician
or replaced by original spare parts
Pull out transport locking pin (5)
Replace saw blade (37)
Allow motor to cool and proceed working with less pres-
sure
Hold the work piece firmly and cut off the motor immediate-
ly. Replace then the saw blade.
Replace saw blade
Replace saw blade
Mount saw blade properly
Switch off saw, remove chips and connect exhaust system
Switch off saw, remove chips and increase exhaust power
(air velocity ≥ 20 m/sec at chip exhaust neck.
Remove chips
20
Advertenties
Hoofdstukken
Inhoudsopgave
