Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Fig. 5
Install the wiring system and prepare the air venting hole (Fig. 1).
Insert the appliance in the hole (Fig. 4a).
Tighten the 2 screws inside the appliance (Fig. 5) until it fits snug on the bottom of the wall unit. Do not tighten the two screws
strongly to maintain the two metallic clamps in the right position.
To get optimal conditions the air venting pipe should: be as short as possible, have the lowest number of bends (max bende angle:
90°), be made of material approved by local authorities (according to the State), have its inner side as regular and smooth as
possible. It is moreover recommended to avoid drastic changes of pipe cross section (recommended diameter: 150 mm). The
device is provided with a 150-125 cm reduction.
Connect the air exit tube with the device air outlet (Fig. 1): use a flexible tube and stop it in the device air outlet through a metallic
clamp (tube and clamp are not provided).
Rimontare i filtri antigrasso.
Make the electrical connection of the hood by means of the power supply cable.
Make the electrical connection between the hood and the external motor by means of the proper terminal board (Fig. 6):
take off the cable clamp A and the cover B of the wiring junction box. Fix the connection cable of the motor onto the
terminal board C. Reassemble the cable clamp A and the cover B of the junction box. The other end of the cable must be
fixed onto the terminal board of the external motor.
Fig. 6
B
A
C
DEVICE DISASSEMBLY
Remove the grease filter .
During the following operations always support the device.
Tighten the 2 screws inside the device (Fig. 5); moving
the 2 small tongues toward the device inside using the
right carvings (Fig. 7); pull out the device from its side.
Fig. 7
10
Advertenties
Inhoudsopgave
