Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Drilling in wood
Mixing emulsion paint
thin cement mortar,
tile adhesive,
gypsum plaster with mixing pad-
dle
4
Technical data
For details of the rated voltage, current, frequency and/or input power, refer to the power tool's
country-specific type identification plate.
If the tool is powered by a generator or transformer, the generator or transformer's power output must be
at least twice the rated input power shown on the rating plate of the tool. The operating voltage of the
transformer or generator must always be within +5 % and -15 % of the rated voltage of the tool.
Product generation
Weight in accordance with EPTA procedure 01
Speed in 1st gear
Speed in 2nd gear
Maximum torque, 1st gear
Maximum torque, 2nd gear
Impact speed
Diameter, chuck
Tightening torque for change of chuck
4.1
Noise information and vibration values
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This can significantly reduce exposure over
the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Detailed information on the versions of the EN 62841 standards applied here is to be found in the
reproduction of the declaration of conformity
Noise emission values
Sound power level (L
WA
Uncertainty (K
)
WA
Sound pressure level (L
Uncertainty (K
)
pA
18
English
Auger bits
Spade bits (not self-
tapping)
TE-MP 80
TE-MP 110
)
)
pA
≤ 30 mm
≤ 40 mm
In 1st gear
recommended
In 1st gear
recommended
UH 700
01
2.6 kg
900 /min
2,500 /min
80 Nm
29 Nm
40,000 Nm
1.5 mm ... 13 mm
120 Nm
118.
UH 700
110 dB(A)
5 dB(A)
102 dB(A)
5 dB(A)
273761
—
≤ 40 mm
—
—
*273761*
Advertenties
Inhoudsopgave
