Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Refer to "Before first use", "Daily
use", or "Hints and tips" for other
possible causes.
Once you have checked the appliance, deactivate
and activate the appliance. If the problem occurs
again, contact an Authorised Service Centre.
THE WASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem
Poor washing results.
Poor drying results.
There are whitish streaks or blu-
ish layers on glasses and dishes.
There are stains and dry water
drops on glasses and dishes.
The dishes are wet.
The interior of the appliance is
wet.
Unusual foam during washing.
Traces of rust on cutlery.
32
For alarm codes not described in the table, contact
an Authorised Service Centre.
Possible cause and solution
•
Refer to "Daily use", "Hints and tips" and basket loading
leaflet.
•
Use more intensive washing programmes.
•
Clean spray arm jets and filter. Refer to "Care and Clean-
ing".
•
Tableware has been left for too long inside a closed appli-
ance.
•
There is no rinse aid or the dosage of rinse aid is not enough.
Set the rinse aid dispenser to a higher level.
•
Plastic items may need to be towel dried.
•
For the best drying performance activate the option XtraDry
and set AirDry.
•
We recommend to always use rinse aid, even in combination
with multi-tablets.
•
The release quantity of rinse aid is too much. Adjust the rinse
aid level to a lower level.
•
The quantity of detergent is too much.
•
The released quantity of rinse aid is not sufficient. Adjust the
rinse aid level to a higher level.
•
The quality of the rinse aid can be the cause.
•
For the best drying performance activate the option XtraDry
and set AirDry .
•
The programme does not have a drying phase or has a drying
phase with low temperature.
•
The rinse aid dispenser is empty.
•
The quality of the rinse aid can be the cause.
•
The quality of the multi-tablets can be the cause. Try a differ-
ent brand or activate the rinse aid dispenser and use rinse
aid and multi-tablets together.
•
This is not a defect of the appliance. it is caused by the hu-
midity in the air that condenses on the walls.
•
Use the detergent for dishwashers only.
•
There is a leak in the rinse aid dispenser. Contact an Author-
ised Service Centre.
•
There is too much salt in the water used for washing. Refer to
"The water softener".
•
Silver and stainless steel cutlery were placed together. Avoid
to put silver and stainless steel items close together.
Advertenties
Inhoudsopgave
