Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Hold the tool tight with both hands. Locate the tool slightly inclined. Once
the drill bit is in the material (approx. 1/8 to 1/4 of the circumference), bring
the tool into an angle of 90 degrees and continue drilling.
Take care that the drill bit is not out of line.
Advance the tool according to bit diameter and machine power. Observe
the LED in the handle.
If it lights red, reduce your pressing force.
In case the bit gets jammed, to not dry to release it by switching the
tool on and off. This would cause premature wearing of the safety clutch.
Switch the tool off immediately and unfix the drill bit by turning to the left or
right using an appropriate open-end wrench. Cautiously pull the tool out of
the borehole.
Use of a water suction ring is mandatory for „overhead drilling".
Diamond drill bits with a 1 ¼" UNC female thread and R ½" male thread
can be screwed directly onto the working spindle.
Use only appropriate drill bits for the material to be drilled in. You can
protect your tool by using only well balanced drill bits without deformation.
Make sure that the diamond segments have sufficient cutting clearance
towards the bit body.
Attention!
When you use or sharpen the machine, it might heat up enormously.
You could burn your hands or get cut or ripped by the segments.
Therefore, always use protective gloves when changing the drill bit.
The drilling spindle has a right-hand thread.
To ease screwing on and off, always use a SW 32 open-end wrench at the
drilling spindle.
Never use a hammer, because this may damage both the drill bit and the
tool.
Some water-resistant grease on the drilling spindle threat or a copper ring
between spindle and drill bit will simplify removal of the drill bit.
After Drilling
When you have finished drilling:
Pull the drill bit out of the hole.
Turn the motor off by using the motor switch and not the PRCD
switch.
Close the water supply.
Drill Bits
Changing Drill Bits
24
Advertenties
Inhoudsopgave
