Inhoudsopgave
Advertenties
PREPARATION AND CHECKS
BEFORE USE
To carry out this series of
checks, place the machine
on stable and level ground
with the isolator key [1]
and the battery pack
removed from the
machine.
ASSEMBLY OF THE HANDLE
1. Ensure that the grass catcher is not installed.
2. Attach the handle [2] to the deck frame so that the cable(s) is/are
on the left side.
3. Install the two bolts [3] to the handle fixing points [4] from the
inside of the handle. Fix them with two handle fixing knobs [5].
Make sure the knobs are securely tightened.
[4]
ASSEMBLY OF THE GRASS CATCHER
Insert the frame [2] into the grass catcher fabric [3] and fit the plastic
edges [1] to the frame.
[1]
[2]
[1]
[5]
[3]
[3]
[1]
4. Check that the cable(s) pass(es) over the left handle fixing knob
and are attached to the left side of the handle with tie straps [6]
as shown in the figure.
HRG466XB
HRG416XB
CHECKING THE GRASS CATCHER
[2]
Before use, ensure that the grass catcher closing device is
correctly closed (discharge cover).
Even in normal use, the grass catcher tends to wear. Regularly
check that it is not frayed or torn. A worn out grass catcher
must be replaced. Replace a damaged grass catcher with
Honda Genuine parts.
Grass catcher removal:
1. Raise discharge
cover [7], grasp
handle [8] and
remove grass catcher
[9] while keeping it in
an upright position.
Grass catcher fitting:
1. Raise the discharge
cover and hook the
front of the grass
catcher on the
machine's attachment lugs [10].
NOTE:
• The machine operates like a vacuum cleaner; it blows air into the
grass catcher sucking up the grass cuttings. Empty the grass
catcher before it is full to help emptying and minimizing the
dropping of grass cuttings. Bagging performance will diminish
after the grass catcher becomes about 90% full.
• HRG466XB only: Mulching is a natural fertilisation technique. The
grass is no longer collected in the grass catcher, but is finely ground
and deposited on the lawn. The grass cuttings chopped up in this way
decompose in the sun and form a natural humus which can produce
a quarter of the annual fertilisation requirement of your lawn.
• In addition to its fertilising role, mulching protects the ground,
limits evaporation of water during hot periods and relieves you of
the task of collecting the grass.
PREPARATION OF THE BATTERY PACK
A charged battery pack must be installed to the machine to operate
the machine. Please refer to the
pack.
250 mm
160 mm
[6]
[6]
[6]
300 mm
264 mm
[10]
[9]
page 6
for handling of the battery
[6]
drive clutch cable
[6]
[7]
[8]
5 EN
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
