Advertenties
Beschikbare talen
Beschikbare talen
3
Installation
B
Please remember that the
manufacturer shall not be held liable
if the information given in the user
guide is not observed.
Points to be considered
when re-transporting your
refrigerator
1. Your refrigerator must be emptied and
cleaned prior to any transportation.
2. Shelves, accessories, and etc.
have to be fastened securely by
adhesive tape against any jolt before
repackaging.
3. Packaging must be tied with thick
tapes and strong ropes and the
rules of transportation printed on the
package must be followed.
Please do not forget...
That recycled material is an
indispensable source for the nature
and for our national resources.
If you would like to contribute to the
recycling of the packaging materials,
you can get further information from
the environmental bodies or local
authorities.
Before operating your
refrigerator
Before starting to use your refrigerator
check the following:
1. The interior of the refrigerator has to
be dry and it is possible for the air
to circulate freely at the back of the
appliance.
2. You can install the 2 spacers as
illustrated in the figure. Spacers
will provide the required distance
between your refrigerator and the wall
in order to allow the air circulation.
(The illustrated figure is only an
example and does not match exactly
with your product.)
All manuals and user guides at all-guides.com
3. Clean the interior of the refrigerator as
4. . Plug the refrigerator into the outlet.
5. . You will hear a noise as the
6. . The front edges of the refrigerator
Electric connection
Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
• The connection must bein
• The power cable plug must be easily
• Extension cords and connector must
B
9
EN
recommended in the "Maintenance
and cleaning" section.
When the door is open the interior
light in the refrigerator compartment
will be switched on.
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
may feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.
accordance with with national
regulations.
accessible after installation.
not be used for connection.
A damaged power cable must be
replaced by a qualified electrician.
Advertenties
