Advertenties
Beschikbare talen
Beschikbare talen
Commissioning (COMpact 5200R/5500R)
Removing a Module
1.
Unlatch the board lock, for example with your
right thumb.
2.
Remove the module with your other hand.
Closing the Casing
Requirements:
•
Screw driver (Phillips)
1.
Remove the dummy panels at those points where modules
have been inserted by pressing them outward from the inside,
for example with your thumb.
Note: Dummy panels that have been removed can be
reinserted any time. For a COMpact 2FXO module with only
two RJ-45 sockets you can break a dummy panel into halves
at intended breakpoint at the centre and reinsert one of the
halves.
2.
Place the front panel onto the casing.
3.
Secure the front panel with its four screws.
Connecting the PC
Requirements:
•
Available network socket on the PC or in the network of the PC
1.
Insert one end of the accompanying network cable into the network
socket on the PC or in the network of the PC.
2.
Insert the other end of the network cable into the RJ-45 socket of the
CPU module.
Turning on the PBX
Warning: Touching voltage-carrying conductors or telephone connections can cause
life-threatening electric shocks.
• Close the casing before you put the PBX into operation.
Note: If you have a USB memory stick with a configuration for automatic loading
(auconfig.cfg), insert it into the USB socket (USB host) of the CPU module before you
switch on the PBX. The configuration data stored on the USB memory stick will
automatically be saved to the PBX after switching on. The PBX restarts afterwards.
48
COMpact 5200/5200R/5500R - Instructions V03 03/2019
Advertenties
