Advertenties
Beschikbare talen
Beschikbare talen
modules. Make sure that any repairs requiring the casing cover to be removed are
carried out by the manufacturer.
Warning: Power surges, which may occur during electrical storms, can cause life-
threatening electric shocks, or damage or destroy the PBX.
• Do not touch the PBX or any devices connected to it during an electrical storm.
1.
Unlatch both locks simultaneously by
compressing each with thumb and index
finger.
2.
Lift the cover and remove it completely from
the casing.
Wall-Mounting the PBX
Warning: Touching voltage-carrying conductors or telephone connections can cause
life-threatening electric shocks.
• Mount the PBX close of an earth wire (potential compensation bar of the house
installation or protective earth conductor). Connect the PBX's earth connection to
the earth wire with a connecting cable whose conductor diameter is at least 2.5 mm
Warning: Liquid entering the casing can cause life-threatening electric shocks or
damage or destroy the PBX.
• Only operate the PBX in closed, dry rooms.
Caution: Overheating can damage or destroy the system.
• Note the ambient temperature values indicated in the technical data.
• Make sure that heat produced by the device can be adequately vented into the
environment. Do not install the system in a cabinet without adequate air circulation.
• Never cover the air vents of the casing.
Important: Mechanical loads and electro-magnetic fields can impair PBX operation.
• Avoid mechanical loads (e. g. vibrations).
• Avoid the proximity of devices that generate electro-magnetic fields (e. g., radio
sets, professional radio equipment, amateur radio equipment, mobile phones,
DECT systems, WLAN routers, etc.).
• Protect the PBX from dirt, excessive dust, condensation, caustic liquids, and steam.
Requirements:
•
3 screws and 3 dowels
•
Connections close to the installation site:
– Freely accessible Schuko socket
– Wall socket or NT provided by the network provider; if the wall socket/NT is relatively
far away from the PBX, permanent cabling must first be laid between the devices
COMpact 5200/5200R/5500R - Instructions V03 03/2019
Commissioning (COMpact 5200)
²
.
41
Advertenties
