Advertenties
Beschikbare talen
Beschikbare talen
LIPROTEC
5.3 Selecting Bluetooth mesh
receivers
Once the Bluetooth mesh receivers have been assigned to
groups, these groups can be selected and controlled using
the Bluetooth remote control:
• All Bluetooth mesh receivers at the same time (
• All Bluetooth mesh receivers in a group (buttons 1-4)
Selecting groups only works if the signal lamp on the remote
control is not flashing and is not lit up faintly. If no input is
made on the remote control for five seconds, the signal lamp
goes out and the groups can be selected.
Selecting Bluetooth mesh receivers
1. Make sure that group mode is activated. To do this, do not
press any buttons on the Bluetooth remote control for five
seconds.
2. To select an individual group, press the button allocated to
it (1–4) on the Bluetooth remote control.
> All the LED modules that are connected to the Blue-
tooth mesh receiver in the group flash briefly once.
These LED modules can now be controlled jointly.
3. To select all the connected Bluetooth mesh receivers si-
multaneously, press the
> All the LED modules that are connected to intercon-
nected Bluetooth mesh receivers flash briefly once.
These LED modules can now be controlled jointly.
button.
EN
button)
37
Advertenties
