Advertenties
Beschikbare talen
Beschikbare talen
LIPROTEC
Bluetooth mesh
receiver type
Output 3
Output 4
Output 5
Connecting Bluetooth mesh receivers to LED strips
The different options for attaching Bluetooth mesh receivers
to the LED strips are described in the "LED Strips Instruction
Manual".
Connecting Bluetooth mesh receivers to the power
supply
Illustrated instructions
Note the information in the "Power Supplies Instruction Man-
ual".
1. Pull the mains plug of the power supply out of the socket
and wait 10 seconds.
2. Use a screwdriver to unscrew and remove the cover for
the 24 V terminals on the power supply.
3. Fit the connection cable for the 24 V input on the Blue-
tooth mesh receiver to the 24 V terminals of the power
supply and screw it tight. Note the polarity of the connec-
tion cable.
4. If the cable is not long enough, lengthen the connection
cable to a maximum of 2 m. To do this, use a LIPROTEC LT
ZK 2A cable and two LIPROTEC-ZKL clamp connectors.
W receiver
–
–
–
» "V" on page 6
RGB+W receiver
Green (-), max. 2.0 A
Red (-), max. 2.0 A
Blue (-), max. 2.0 A
EN
31
Advertenties
