Advertenties
Beschikbare talen
Beschikbare talen
5. Attach the cover for the 24 V terminals. Tighten the screws
hand-tight only.
> The Bluetooth mesh receiver is connected to the
power supply.
4.2 Installing the wall bracket for the
Bluetooth remote control
Illustrated instructions
The wall bracket for the Bluetooth remote control can either
be stuck to the wall with adhesive or fastened to the wall us-
ing screws.
Fastening the wall bracket with adhesive strips
1. Clean the surface to which you wish to attach the wall
bracket and clean the back of the bracket.
2. Remove the protective film from one side of one of the ad-
hesive pads.
3. Stick the first adhesive pad to the back of the wall bracket,
centrally above one of the two holes.
4. Remove the protective film from one side of the second
adhesive pad.
5. Stick the second adhesive strip centrally above the other
through hole.
6. Remove the second protective film from both adhesive
strips.
7. Stick the wall bracket to the wall with the arrow pointing
upwards and press it against the wall for a few seconds.
32
» "IV" on page 5
Advertenties
