Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH
50
49
To keep the set bevel angle from chang-
ing during cutting, it must be locked
again by the lock lever (50).
Release lever for bevel tilt stop
The blade tilt setting has end stops at 0°
and 45°. For special bevel cuts (under-
cutting) the bevel angle can be in-
creased by 1.5° in both directions.
Withdraw bevel angle limitation stop
(51) and place over the right-hand
cam plate = bevel angle of saw
blade adjustable between –1.5° and
45°.
Withdraw bevel angle limitation stop
(51) and place over the left-hand
cam plate = bevel angle of saw
blade adjustable between 0° and
46.5°.
On/off switch
To stop = press upper switch (52).
To start = press and hold lower
switch (53) for 1 - 2 seconds.
22
6.4
Adjusting rip fence
For use as rip fence the long fence ex-
trusion (54) must be installed. It is
mounted on the guide extrusion at the
front of the saw table.
– Position rip fence to the right of the
saw blade.
The marking in the magnifying glass
shows the set distance between the
rip fence and the saw blade on the
scale.
– Release lock lever (55) of rip fence
and shift rip fence until marking in
magnifying glass indicates the de-
sired distance to the saw blade.
Press lock lever (55) downwards to
lock.
– For ripping, the fence extrusion (54)
51
must be parallel with the saw blade
and locked in position by the lock le-
ver (55). Press lock lever down-
wards to do this.
– Knurled nuts (56) for attaching the
fence extrusion. After loosening the
two knurled nuts (56), the fence ex-
trusion can be removed and shifted:
52
53
Small edge:
– for cutting thin stock;
– when the saw blade is tilted.
Wide edge:
– for cutting thick stock (max. 87
mm).
6.5
Adjusting pointer on rip
fence
1. Align rip fence with saw blade.
2. Loosen rip fence pointer fixing
screw.
3. Bring pointer on rip fence and "O" on
scale into alignment.
4. Retighten rip fence pointer fixing
screw.
3
Note:
To avoid stock jamming when cutting
along the rip fence:
slide rip fence all the way to the right ta-
ble edge and then back to the required
cutting width.
3
Note:
54
Adjust parallel stop (if necessary): To
55
prevent the workpiece from jamming be-
tween parallel stop and saw blade, the
parallel stop must be aligned to the saw
blade, or set to a max. of 0.3 mm open-
ing to the rear. To adjust it, release the 2
screws on the upper side of the parallel
stop and then tighten again.
6.6
Setting mitre fence
The mitre fence (58) is inserted into the
table slot from the table's front edge.
56
For mitre cuts the mitre fence turns to
60° in both directions.
For 45° and 90° mitres positive stops
are provided.
To set a mitre angle: loosen locking
handle (57) by turning it counter-clock-
wise.
A
Risk of injury!
When cutting with the mitre fence
the handle must be firmly tightened.
The auxiliary fence extrusion can be
taken off and reversed after loosening
knurled nut (59).
57
59
58
Advertenties
