Advertenties
Beschikbare talen
Beschikbare talen
Safety symbol
Danger!
Failure to observe the
following warnings can
result in serious injury
or damage to property.
Read the operating instruc-
tions.
Never place hands into
running saw blade.
Wear protective goggles
and
ear protectors.
Never operate the tool in a
damp or wet environment.
3.4
Safety devices
Riving knife
The riving knife (33) prevents the work-
piece from being caught by the rising
teeth of the saw blade and being thrown
against the operator.
Always have the riving knife installed
during operation.
Blade guard
The blade guard (34) protects against
unintentional contact with the saw blade
and from chips flying about.
Always have blade guard installed dur-
ing operation.
33
34
Push stick
The push stick (35) serves as an exten-
sion of the hand and protects against
accidental contact with the saw blade.
Always use push stick if distance be-
tween saw blade and rip fence is less
than 120 mm.
.
Guide the push stick at an angle of 20°
... 30° against the saw table's surface.
If the push stick is not used, it has to be
stored with the machine.
Replace push stick if damaged.
4.
Installation
A
Ensure firm footing and keep
your balance at all times.
Installation without machine stand:
1. Lift saw with two persons out of
packaging.
2. Place saw down on stable table or
work bench.
3. Bolt saw firmly onto table or work
bench.
Installation with machine stand:
1. Lift tool with two persons out of
packaging.
2. Place tool on ground.
3. Lift tool by handles and set up on
edge
4. Pull out handles (36), turn them and
engage them.
5. Fold out the two table legs. To do
this, press the red turning lever (37)
downwards (with your foot or hand)
35
and swing down the table legs.
6. Tilt the tool slightly to the rear and
press down both table legs. The red
turning levers (37) must engage.
7. Fold out the upper two table legs. To
do this, push the red turning lever
(38) to the right and swing the table
legs downwards.
The red turning levers must engage.
.
8. Hold the saw round the centre of the
upper frame. Pull up saw and set
down. (Hold adjustable base in posi-
tion with foot to prevent slipping of
the saw during installation).
36
9. Compensate for floor irregularities
with the adjustable base (39).
ENGLISH
37
38
19
Advertenties
