Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Cleaning, Checks and Storage of the home bike:
1. Cleaning
Use only a less wet cloth for cleaning.
Caution: Never use benzene, thinner or other aggressive cleaning
agents for surface cleaning as this damage caused.
The device is only for private home use and for use suitable indoors.
Keep the unit clean and moisture from the device.
2. Storage
Remove the batteries from the computer while intending the unit
for more than 4 weeks not to use. Choose a dry storage in-house.
Cover the bike to protect it from being discolor by any sunlight and
dirty through dust.
3. Checks
We recommend every 50 hours to review the screw connections
for tightness, which were prepared in the assembly.
Start your warm up by walking on the spot for at least 3 minutes and then perform the following gymnastic exercises to the body for the training phase to
prepare accordingly. The exercises do not overdo it and only as far run until a slight drag felt. This position will hold a while.
Reach with your left hand
behind your head to the right
shoulder and pull with the
right hand slightly to the left
elbow. After 20sec. switch
arm.
After the warm-up exercises by some arms and legs shake loose.
Don't finish the exercise phase abruptly, but will cycle leisurely something without resistance from to return to the normal pulse-zone. (Cool down) We re-
commend the warm-up exercises at the end of the training be conducted and to end your workout with shaking of the extremities.
Warm up exercises (Warm Up)
Bend forward as far forward
Sit down with one leg
as possible and let your
stretched out on the floor
legs almost stretched. Show
and bend forward and try
it with your fingers in the
to reach the foot with your
direction of toe. 2 x 20sec.
hands. 2 x 20sec.
25
Troubleshooting
If you cannot solve the problem with the following information,
please contact the authorized service center.
Problem
Possible Cause
Computer
No Batteries insert
has no value
or batteries empty
at Display if
you press any
key.
Computer is
Sensor impulse
not counting
missing base on
data and do
not well plugged
not switch
connection
on after start
cycling.
Computer is
Sensor impulse
not counting
missing base on
data and do
not correct position
not switch
of sensor.
on after start
cycling.
No pulse
Pulse cable is not
value
plugged in.
No pulse
Pulse sensors not
value
well connected
Resistance
Connection of resi-
don't change
stance not well
Kneel in a wide lunge for-
ward and support yourself
with your hands on the
floor. Press the pelvis down.
Change after 20 sec leg.
Solution
Check the position of batte-
ries at battery compartment or
replace batteries.
Check the plug connections at
computer and inside of handle-
bar support.
Take off the cover and check
the distance between magnet
and Sensor. The magnet at
flywheel should have only less
than < 5mm distance against
the sensor position.
Check the separately pulse
cable is well connected with
computer.
Screw out the screw for pulse
measurement and check if
plugs are well connected and no
damage at pulse cable.
Check the resistance connec-
tion at magnetic bracket as
manual mention.
Advertenties
Inhoudsopgave
