Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Possible faults and their remedies
Most faults which can occur can be rectified by the following, sim-
ple steps.
1. The belt (36) no longer runs evenly
To achieve even running and to reduce the friction between the
belt (36) and the board (35), you should apply a silicone-based
lubricant occasionally on the slip surface beneath the belt (36).
Ensure that the lubricant is not based on an oil or petroleum com-
pound.
2. The belt (36) no longer runs centrally or slides
a) If the belt (36) has run to the left of the direction of running, turn
the left
screw (5) clockwise and the right screw (5) anticlockwise by a
quarter of a revolution each. Run briefly on the belt.
If the belt still does not run centrally, repeat the above procedure.
b) If the belt (36) has run to the right of the direction of running, turn
the left screw (5) anticlockwise and the right screw (5) clockwise
by a quarter of a
revolution each. Run briefly on the belt. If the belt still does not run
centrally, repeat the above procedure.
c) If the belt (36) slips, turn both screws (5) clockwise by a quarter
of a revolution. Run briefly on the belt. If the belt (36) still slips,
repeat the above procedure.
Instruction for a mechanical treadmill, slowed
down magnetically.
Settle the treadmill on an even ground and lock it with the safety
knob (54) for the training start.
And also lock it with the safety knob (54) for the fold up position.
The stability of the piece of apparatus is not to be endangered
by putting something under the treadmill like a piece of wood or
something similar. Guarantee before starting the training that tre-
admill is not loaded higher than with the maximum permissible
weight of body and that there is enough space for security of 2
000 mm x 1 000 mm.
Run in the middle of the running surface, hold yourself tight and
don't step on the slip board (35) or on the foot mats (10). Only run
in increasing with look at the Computer on the treadmill during the
running. In emergency step of the treadmill lateral and hold on to
the handle (29).
When nobody is on the treadmill it will stop automatically.
Red area is dangerous area, if the running belt is in the red
area , it needs to be adjusted after machine stopped.
The yellow area is safe area
24
Advertenties
Inhoudsopgave
