Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Translation of the original instructions
USE IN STARTER MODE (INTERFACE, P.5)
Do not disconnect the battery fom the vehicle. Connecting the battery can lead to the vehicle's memory
loss and a potential impossibility to restart it.
1. Connection (p.15).
2. Press the selection button (
3. Start the preload by pressing the START / STOP button (
• The «START ENGINE» mode detects sulfated batteries and will thus refuse to start the vehicle. The
machine will automatically start the desulfating procedure in order to protect on-board electronics.
• If the battery is excessively damaged (e.g. sulfated), the charger will block the start. In this event, the
startium intermittently indicates « CIP » (Charge in Progress) and 0%. This means that battery recovery
is in progress. As long as «CIP» appears on the display, it is not possible to start the vehicle.
Make sure to follow the recommended precharge time, depending on the battery capacity.
Product
STARTIUM 330E
STARTIUM 480E
STARTIUM 680E
STARTIUM 980E
4. Once the precharge is done, go to the vehicle's dashboard. The «start» feature will activate when the first attempt
to start is initiated (by turning the key). The attempt time must be for 10 secs maximum (a countdown appears on
the display).
If your engine does not start, wait 2 minutes between each start attempt.
Nb : If the vehicle does not start, it may be a problem other than a faulty battery e.g. alternator, glowplug...
ALTERNATOR TEST
If the vehicle battery is regularly out of order, the problem may come form the alternator.
The STARTIUMS have an «alternator test» feature (
displaying the voltage and the perrcentage.
To use this feature, the vehicle must be started :
1. Connection (p.15).
2. Select the «Test Alternator» function with the selection button (
3. The display shows a percentage. It provides information on the alternator's state of health according to the fol-
lowing table:
Between 0 and a 100%
At a 100%
Between a 100% and
200%
PROTECTIONS
These clamps have been designed for maximum protection :
• The charging clamps are fully insulated.
• A fuse guarantees protection against polarity inversion and short circuits. Replacing it requires manual intervention.
18
STARTIUM 330E / 480E / 680E / 980E
- 13) until you reach the START ENGINE mode (1).
Battery capacity
40 - 80 Ah
40 - 120 Ah
50 - 180 Ah
50 - 240 Ah
Undercharge fault, the battery is not correctly charged.
Alternator all good.
Overcharge fault.
STARTIUM 330E
FUSE
100A
- 9).
Starting
Instantaneous
Instantaneous
Instantaneous
Instantaneous
- 12). It can show the alternator's charge capacity by intermittently
- 12).
STARTIUM 480E / 680E
FUSE
200A
Battery capacity
80 - 120 Ah
10 min pre charge
120 -160 Ah
10 min pre charge
180 - 200 Ah
10 min pre charge
-
STARTIUM 980E
FUSE
250A
EN
Starting
-
Advertenties
Inhoudsopgave
