Maintenance Schedule - Husqvarna pullman Ermator DE 110 SH Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

WARNING:

not make a hole in the filter. Risk of dust

dispersion.

WARNING:

obey all local regulations to dispose the

dangerous dust correctly, before and during

maintenance.

WARNING:

instructed person, must do a technical

inspection at least annually. The technical

inspection includes an inspection of the

Maintenance

Do the filter purge procedure. Refer to

To remove dust particles from the prefil-

ter during operation on page 12 .

Look for signs of wear or damage of the

dust release rubber cone.

Do a check of the power plug and the

power cord.

Look for signs of wear, damage or loose

connections of the controls before the

unit is connected.

Do a check of the hose and the hose

connectors.

Look for signs of wear or damage of the

plastic parts.

Do a check of the lifting eyes.

Make sure that the Longopac is correct

and that it is correctly attached. Refer to

To install a new Longopac bag cassette

on page 12 .

Do a check of the filter purge function.

Do a check of the wheels. Look for

damage and bad connections.

Do a check of the filter seals.

Do the filter purge procedure. If the

suction continues to be not sufficient,

clean the prefilter with water. Refer to

To clean the prefilter with water on page

16 .

Replace the cleaned prefilter if the suc-

tion continues to be not sufficient. Refer

To replace the prefilter on page 17 .

1979 - 001 - 23.02.2023

Make sure that you do

Make sure that you

The manufacturer, or an

Before

each use

filters for damage, air tightness of the

product and correct function of the

control mechanism. In addition the filtration

efficiency of the product must be tested at

least annually, or more frequently as may

be specified by national requirements. If the

test is not conducted the HEPA filter must be

replaced by a new one.