Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
deviation does not belong to the scope of warranty, mainly by the user in accordance with the manual self-
maintenance. Deviation will seriously damage the running belt, must be found in time, timely correction.
6. Adjustment of the motor's belt
The motor belt of treadmill is adjusted in the factory. However, after a period of use, there may be slack or
slip phenomenon. The step of adjustment: 1.Turn the adjusting screw counterclockwise with wrench.
3.The adjustment range shall be subject to the belt load not slipping.
4.Noted: Regular cleaning of belts and pulley grooves.
7. Troubleshooting
Part of the treadmill
The problem
The treadmill doesn't work
Run with it
Not moving smoothly
The running belt slipped
Part of the console
Fault code
Fault description
Abnormal
communication:
between control and
E 1
console after power-
The motor cord is not
connected properly.
E 3
Possible causes
A is unplugged
B the security key is not embedded
C circuit signal system open
D power supply not turned on
E the fuse blew
A not enough lubrication
Running straps are too tight
A the running belt is too loose
B the belt is loose
Controller shutdown into a fault state. Unable to start. The console shows the failure
Possible reasons: control and the console communication is blocked, check the
connection of the communication line, ensure that each core fully inserted. Replace
on.
Shutdown into the fault state, the console buzzer sound 9times, and showing the fault
code. If it returns to normal after shutdown, it can enter the standby state and
Possible causes: Check whether the motor wire is connected, keep the wire is
connected. Check whether the controller has any odor, replace the controller;
Embed the safety key in the panel
Check the controller input and signal line
Place power switch in NO position
Using a methyl silicone oil lubricant
Adjust your running bands for tightness
Adjust your running bands for tightness
Trouble shooting
code, and the buzzer beeps three times.
the connection line if it is broken..
restarted.
29
Maintenance methods
Plug into socket
Replace the fuse
Adjust drive belt tightness
Advertenties
Inhoudsopgave
