Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
˜ Installing/changing
disc (fig. F)
1. Press the spindle lock button
2. Turn the mounting spindle
spindle lock fixed the mounting spindle.
Keep and continue to hold down the
spindle lock button.
3. Release the clamping nut
key
. You can release the spindle lock
[
]
button.
4. Set the desired disc onto the mounting
flange
(fig. B). The label on the disc
[
]
should always face the product.
NOTE
If the rotary direction is indicated on
u
your disc, ensure that it corresponds to
the rotary direction of the product when
mounting. This is indicated on the product
next to the spindle lock button (
Ensure that the mounting flange (fig. B)
u
is placed on the product in such a way
that the recesses in the flange grip into
the edge of the product. The mounting
spindle must turn simultaneously when
you turn the flange.
5. Set the clamping nut on the mounting
spindle again. The flat side of the clamping
nut must face the attachment tool if the
thickness of the disc receptor is < 5 mm.
If the thickness of the disc receptor is
≥ 5 mm, turn the clamping nut (fig. B).
6. Press the spindle lock button and turn the
mounting spindle, until the spindle lock
button holds the spindle flange in a fixed
position. Pull the clamping nut tight again
using the chuck key. You can let go of the
spindle lock button.
18 GB/IE/NI
˜ Operation
.
[
]
until the
[
]
with the chuck
[
]
).
m
CAUTION! Risk of injury!
Always remove the mains plug
u
working on the product.
Only use grinding discs and accessories
u
recommended by the manufacturer.
Using other attachment tools and other
accessories can represent a risk of injury
for you.
Only use accessory parts which bear
u
information about the manufacturer, type
of connection, dimension and permitted
number of revolutions.
Only use accessory parts where the
u
printed rotational speed is at least as
high as what has been specified on the
name plate of the product.
Do not use any broken, cracked, or
u
otherwise damaged grinding discs.
Never operate the product without
u
protective equipment.
Support the plates or workpieces in order
u
to reduce the risk of kickback from a
jammed cutting disc. Large workpieces
may bend under their own weight. The
workpiece must be supported on both
sides of the disc, not only near the cutting
disc, but also at the edge.
Keep your hands away from the disc
u
when the product is in operation. Risk of
injury.
NOTE
Information on replacement
Never operate the product without
u
protective equipment.
before
[
]
Advertenties
Hoofdstukken
Inhoudsopgave
