Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
˜ Scope of delivery
1 LED outdoor light
2 Wall plugs (Ø 6 mm)
2 Screws
1 Terminal cover
1 Cable gland
1 Set of mounting and operating instructions
General safety instructions
BEFORE USING THE PRODUCT, FAMILIARISE
YOURSELF WITH ALL OF THE SAFETY
INFORMATION AND INSTRUCTIONS FOR
USE! WHEN PASSING THIS PRODUCT
ON TO OTHERS, ALSO INCLUDE ALL THE
DOCUMENTS!
DANGER TO LIFE AND
ACCIDENT HAZARD FOR
TODDLERS AND SMALL
CHILDREN! Never leave children unattended
with the packaging material . The packaging
material represents a danger of suffocation .
Children frequently underestimate the dangers .
Keep children away from the product at all
times .
This product may be used by children age
8 years and up, as well as by persons with
reduced physical, sensory or mental capacities,
or lacking experience and/or knowledge, so
long as they are supervised or instructed in
the safe use of the product and understand
the associated risks . Children should not be
allowed to play with the product . Cleaning and
user maintenance should not be performed by
children without supervision .
DANGER! RISK OF
ELECTRIC SHOCK!
Always check the product for damage before
connecting it to the power supply . Never use
the product if it shows any signs of damage .
Prior to installation, verify that the mains
voltage on site corresponds with the operating
voltage required for the product (230 V∼
50 Hz) . Otherwise do not install the product .
CAUTION! RISK OF BURN INJURIES! To
prevent burns, verify the product is switched off
and has cooled down for at least 15 minutes
before touching it . The product can become
very hot .
CAUTION! FIRE HAZARD! Fit the
product so that it is at least 0 .5 m
0 .5 m
away from the material to be
illuminated . Excessive heat can result in a fire .
CAUTION! RISK OF INJURY!
Broken lamp glass must be replaced
before any further use is made of the
product .
The product is only intended for installation out
of normal reach .
This product does not contain any parts that
can be serviced by the user . The LEDs and
built‑in LED control gear cannot be replaced .
If the illuminants fail at the end of their lives, the
entire product must be disposed of .
The spotlight is only suited for use with the
built‑in LED control gear .
˜ Before use
Note: Remove all packaging materials from the
product .
Remove the plastic cover
o
(Fig . B) .
˜ Before installation
Important: The electrical connection must
be established by a qualified electrician
or a person trained to perform electrical
installations . This person must be familiar
with the properties of the product and the
connection regulations .
Before installation: Ensure that the circuit,
o
to which the product will be connected, is
not energised . To do so, remove the fuse or
switch off the circuit breaker in the fuse box
(0 position) .
Use a voltage tester to verify the de‑energised
o
status .
from the product
9 ]
[
GB/IE/NI
7
Advertenties
Hoofdstukken
Inhoudsopgave
