Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
_______________________________________________________________
3
Product description
Dimensions and weight specifications of your product
are provided on the delivery note.
3.1 Technical data
Dimensions and weight
Temperature range at the
place of installation
Relative humidity
Input voltage range
Frequency range
Maximum load capacity
Maximum "ON" duration
Input current
Maximum adjustment range:
Double telescope (Lift 2)
Noise emission
Max. power consumption
during lifting
Power consumption in
standby mode
Memory control panel
Type plates are located on the power lift housing, on
the columns, and under the desktop near the control
panel.
Type plate: symbols – explanation
Double insulation. Double
insulated cables minimise the risk of
electrical shock.
For indoor use. Indicates that
placing the product outdoors is not
allowed.
Read operator's manual. To
indicate that the operator's manual or
card should be read before
continuing the operation.
Rated duty cycle. Maximum
activation time (time on) followed by
a minimum deactivation time (time
off) necessary for the safe operation
of the furniture.
6
Solo Sit-to-Stand Desk
See delivery note
+5°C to +35°C
5% to 80% (non-condensing)
220 to 240 V ˜
50 to 60 Hz
75 kg
2 min. ON/18 min. OFF
2.5 A
650 mm to 1250 mm
<60 dB (A)
240 W
≤ 0.2 W
Standard
CE marking. Used to symbolise the
conformity of the product with the
applicable requirements that the
European Community places on the
manufacturer.
UKCA marking. Used to symbolise
the conformity of the product with
the applicable requirements that the
United Kindom places on the
manufacturer.
Recycling symbol. Used to indicate
conformity with the regulations for
Waste Electric and Electronic
Equipment (WEEE) and the Electrical
and Electronic Equipment Act
(ElektroG). Electrical and electronic
products must be disposed of
separately from household waste at
the end of their service life.
The CE and UKCA marking is located on the
underside of the desktop and can be viewed at any
time.
3.2 Components
The Solo Sit-to-Stand Desk essentially consists of
the following components (the variant descriptions
can be found in the respective chapters):
Tabletop
■
Horizontal structural profile section (bolted to the
■
desktop)
Software and hardware-supported stopping
■
device with a sensor for system protection
Columns with bolted steel pipe runner (88.5 x 48
■
x 1.5 mm), including adjustment screw for
compensating floor unevenness, and a cable duct
Plastic cap, top left/right
■
Desktop support, top left/right
■
Electrical height adjustment:
■
–
Lift 2: Electric motor (650 to 1250 mm), in
column, including software-supported
stopping device and sensor
–
Power lift for lifting height adjustment
–
Standard: Memory control panel with display
for height indication; programming function
for four desk heights
Product description
157238
Advertenties
Hoofdstukken
Inhoudsopgave
