Download Inhoudsopgave Inhoud Print deze pagina

Errors And Malfunctions; Safety Instructions - Steelcase Solo Sit-to-Stand Desk Bedieningshandleiding

Verberg thumbnails Zie ook voor Solo Sit-to-Stand Desk:
Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 123
_______________________________________________________________
6
Errors and
malfunctions

6.1 Safety instructions

The following information always applies to resolving
problems:
Danger due to voltage!
Contact with voltage can cause
severe injury or death due to electric
shock.
Attach or detach connectors only
when the equipment is de-
energised.
Do not open the housings of the
following components:
- Power lift
- Columns
- Control panel
Signal/Code
Message
The overheating protection circuit has
HOT
been activated.
ISP
The system has detected a collision.
CON followed by
The system has detected a connection
ERR
error.
ERR followed by
An internal error has occurred.
ERROR NUMBER
The control panel is locked.
Table of error messages
Signal/Code
C2
157238
Error messages displayed on the
control panel
If faults occur during operation of the desk, please
check whether it is being operated in accordance
with the user guide. In most cases, this will help you
find and eliminate the problem.
For the Memory control panel, some faults that could
occur are indicated on the display.
The tables below should help you to determine the
cause and correct the error or fault:
Required measure(s)
Wait until the overheated components have cooled down.
Release all buttons and wait until the drive back function
process is completed.
Release all buttons and wait 5 seconds. Then try again.
Disconnect the power supply from the mains connection.
Then disconnect the system from the power supply. Re-
connect the system and use it as usual.
Read the table below to determine the correct corrective
measure for the indicated error code.
To unlock the control panel again, swipe across the display
with a finger.
Message
Overcurrent with motor

Errors and malfunctions

PLEASE NOTE
Risk of damage to electrical equipment!
Do not use the mains cable to pull
the plug out of the socket.
Required measure(s)
Release all buttons and wait 5 seconds.
Then try again.
M em ory
15

Advertenties

Inhoudsopgave
loading

Inhoudsopgave