Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
_______________________________________________________________
Calling up memory positions
Press and hold the corresponding memory
position button (e.g. button "1" or button
"2", etc.).
=
The desktop is moved until the stored
desktop height is reached. The desktop
movement is stopped whenever the button
is released before the memory position has
been reached.
Limiting height adjustability
These settings can limit the desktop
movement range (for example if there is a
rolling file cabinet under the desk or a set of
shelves above it).
The stopping positions for the rolling file
cabinet become the new lowermost end
position, and the shelf stopping positions
become the new uppermost end position.
Move the desktop to the lower half or the
upper half of the movement range.
Press and hold the "SAVE" button for 10
seconds
=
The position is saved.
Changing the displayed unit – CM/INCH
Simultaneously press and hold the buttons
"1", "2" and "Up" for three seconds; then
release the buttons.
=
The letter S and a number (e.g. S 7) are
indicated on the display.
Press and hold the "Up" button until S 5 is
indicated on the display.
=
S 5 is displayed.
Press the "SAVE" button.
=
If the display was previously set to
centimetres (cm), it will now be switched
over to inches (inch) and vice versa.
14
Operating and adjusting
Resetting to factory settings
This function can be used to reset the
system to the factory settings.
Press and hold the buttons shown below for
3 sec.:
a
Press buttons "1" and "2" and the
b
"Up" button
=
The letter S and a number (e.g. S 4) are
shown on the display
Press the "Down" button until S 0 is shown
on the display.
=
The display indicates S 0
Press the "SAVE" button.
=
The system has now been reset to the
factory settings.
157238
Advertenties
Hoofdstukken
Inhoudsopgave
