Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Preparations for use
Q
Fitting the light
Q
Note: Prior to installation, verify there is a socket
nearby within reach of the included power cable
Note: The light can be adjusted to 2 light levels
using the ON / OFF switch
1. Measure up the wall or mounting surface for
drilling the holes. Use a spirit level to improve
accuracy.
2. Mark the distance for the mounting holes
or
.
11
3. Now drill the mounting holes (ø approx. 6 mm,
depth approx. 40 mm). Make sure that you do
not damage any electrical cables during this
operation.
4. Insert the supplied wall plugs
holes. Insert the supplied screws into the wall
plugs
and tighten them, stopping when they
10
project about 3 mm out of the wall or mounting
surface (fig. A).
5. Attach the light using the appropriate mounting
holes
or
to the screws.
11
1
6. When you have attached the light above the
assembly holes
, slide the light housing
11
to the left until it clicks into place.
7. Insert the light connector plug of the mains
lead
into the light connector socket
3
8. Insert the mains plug of the mains lead
a convenient mains socket. Your light is now
ready for operation.
Connecting several
Q
lights together
CAUTION!
Please ensure all under-cupboard lamps have been
connected with the connection cable
connecting the mains plug
Note: Make sure that you only connect a maximum
of 10 linked-up under-cabinet lights of the same
type to one socket.
.
3
.
5
1
into the drilled
10
9
.
2
into
4
before
8
to the mains socket.
4
Install up to 10 lights of the same model next
to each other. To do so, follow steps 1–5 of
the section called "Fitting the light".
Note: Make sure that the distance between
the lights is not more than 15 cm.
Note: Make sure that the distance between
the lights is not less than 10 cm.
Remove the protective head guard
Insert the connecting cable
necting socket
of the light.
6
Insert the second connection of the connecting
cable
into the socket
8
Insert the connection of the power cable
into the socket
of the outer, left-hand light.
2
Connect the mains plug
socket. Your lights are now ready for opera-
tion.
C hanging the light colour
To change the light colour, set the ON / OFF
switch
to the different levels.
5
‒ Level I = Warm white
‒ Level II = Cold white
Switching On / Off
Q
Switch the ON / OFF switch
light on or off.
Move the ON / OFF switch
position to switch the light off.
Directing the light
Q
Never change the direction of the light while
it is switched on.
RISK OF BURNS!
To prevent burns, be sure the light is switched
off and cooled down before touching it. The
illuminants become very hot.
Allow the light to cool down completely.
Turn the strip light
12
Preparations for use
.
7
into the con-
8
of the other light.
2
3
to the mains
4
to turn the
5
to the centre
5
into the desired direction.
GB/IE/NI
9
Advertenties
Hoofdstukken
Inhoudsopgave
