Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The order of the 8 lighting modes is as
follows:
1. Combination (combination of all lighting mode)
2. In wave (LED lighting flashing in changing
frequency)
3. Sequential (LEDs light up alternating)
4. Slo-glo (LEDs slowly light up alternating)
5. Chasing/flash (LEDs flash alternating)
6. Slow fade (LEDs light up and fade out slowly)
7. Twinkle/flash (LEDs light up alternating like
twinkle)
8. Steady on (all LEDs are on)
Press the ON/OFF button
off the product.
Note: The next time the product is switched on,
the last selected light mode is automatically
applied.
Timer function
To switch on the timer function, press and hold
the mode button
6
on. The mode button
indicate the timer function is activated.
Note: The timer will only start to count for 6
hours lighting time once the product light up in
dark. After that, the product will light off auto-
matically. Timer function can be switched on in
the respective desired light mode (1–8).
Note: The timer will be reset for counting 6
hours lighting time based on below 3 situations:
- Manually switch off and on the product
- Manually switch off and on the timer
- Solar panel
exposed to any light source,
9
that lead the product light off
To switch off the timer function, press and hold
the mode button
6
of the mode button
When the timer function is switched off, the
product glows continuously in dark.
again to switch
7
after the product is switched
will light up green
6
again and the green light
will be turned off.
6
Replacing the rechargeable
battery (see Fig. D)
Note: For this step, you will need a cross head
screwdriver.
1. Switch the product off by means of the ON/
OFF button
before removing or inserting
7
the rechargeable battery
2. Open the rechargeable battery cover
the bottom of the solar panel housing
do so, unscrew all screws
using a cross head screwdriver. Then, with the
assist of the ground spike, you can remove the
rechargeable battery cover
3. Take out the used or exhausted rechargeable
battery
.
12
4. Insert a Ni-MH, AA, 1.2 V
rechargeable battery
battery compartment
Note: Ensure correct polarity. This is indicated
in the rechargeable battery compartment
5. Place the rechargeable battery cover
onto the rechargeable battery compartment
again and turn all screws
means of a cross head screwdriver.
6. Make sure that the cables do not get jammed
when you shut the solar panel housing
Maintenance and care
The LEDs cannot be replaced. The product requires
no maintenance.
Clean the product regularly with a dry, lint-
free cloth. Use a slightly dampened cloth to
remove more stubborn dirt.
Troubleshooting
Note: This product has delicate electronic com-
ponents. This means that if it is placed near an
object that transmits radio signals, it could cause
interference. If you notice that the product is mal-
functioning, remove any sources of interference
from the area of the product.
.
12
on
11
. To
1
anti-clockwise
10
easily.
11
/800 mAh
into the rechargeable
12
.
13
13
back
11
13
clockwise by
10
.
1
GB/IE/NI
.
9
Advertenties
Hoofdstukken
Inhoudsopgave
