Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
burns on contact with the skin. Wear suitable
protective gloves at all times if such an event
occurs.
In the event of a leakage of batteries/recharge-
able batteries, immediately remove them from
the product to prevent damage.
Remove batteries/rechargeable batteries if the
product will not be used for a longer period.
Risk of damage of the product
Only use the specified type of battery/
rechargeable battery!
Insert batteries/rechargeable batteries accord-
ing to polarity marks (+) and (-) on the battery/
rechargeable battery and the product.
Use a dry lint-free cloth or cotton swab to clean
the contacts on the battery/rechargeable bat-
tery and in the battery compartment before in-
serting!
Remove exhausted batteries/rechargeable
batteries from the product immediately.
Functioning
The solar panel
installed in the product converts
9
sunlight into electrical energy and stores it in the
rechargeable battery.
The product will automatically light on as it begins
to get dark. The LEDs are a very long-life and en-
ergy-saving light source. The light duration depends
on the amount of sunlight, the angle of light on the
solar panel
and the temperature (the recharge-
9
able battery capacity is temperature-dependent).
A vertical angle of light at temperatures above the
freezing point is ideal. The rechargeable battery
does not achieve maximum capacity until after
several charge and discharge cycles.
In summer a completely drained rechargeable
battery takes about 2 to 4 days to fully recharge
in constant sunlight.
Before use
Note: Remove all packaging materials from the
product.
8
GB/IE/NI
Installation (see Fig. B + C)
1. Push the ground spike
attachment
.
2
2. Slide the solar panel housing
spike attachment
2
installed.
3. Push the ground spike
ground (lawn, flower bed) so it is firmly posi-
tioned upright in the ground.
4. Make sure it is firmly positioned. Do not use
any force when assembling or setting up the
product, e.g. hammer blows. This will damage
the product. For optimal results, set up the prod-
uct in a location where the solar panel
exposed to sunlight for the longest possible
amount of time. Do not put the product under
bushes, trees, canopies etc. as this reduces
the incidence of incoming sunlight. Position the
product in such a way that the solar panel
is not covered or in the shade.
Note: Make sure the solar panel
impacted by other light sources, e.g. yard- or
street lighting, or the product will not switch
on at twilight.
Note: The solar panel
to desired position (see Fig. C) by loosen and
re-tighten the fasten screws
5. You can fix the LED light bulb
surface, twist on a tree or railing with the hang-
ers
by using the mounting material such as
5
cable tie (mounting material is not included).
Operation
Press the ON/OFF button
product. The product will light up only in dark.
Press the mode button
lighting mode. When you reach lighting mode
8, the next press of mode button
the product back into lighting mode 1.
into the ground spike
3
over ground
1
if this has not been pre-
far enough into the
3
is
9
9
is not
9
can be adjusted
9
accordingly.
8
on a desired
4
to switch on the
7
to switch to the next
6
switches
6
Advertenties
Hoofdstukken
Inhoudsopgave
