OPERATION IN CASE OF EMERGENCY
In the event of an emergency, you should:
switch off all working units of the cooker
disconnect the mains plug
call the service centre
some minor faults can be fixed by referring to the instructions given in the table
below. Before calling the customer support centre or the service centre check the
following points that are presented in the table.
PROBLEM
1. A burner does not light
2. A gas ignitor does not
light
3. The flame goes out when
lighting a burner
4. electrical fittings do not
work
5. The programmer display
shows "0:00".
6. the oven lighting does
not work
All manuals and user guides at all-guides.com
REASON
flame openings soiled
break in power supply
break in gas supply
soiled (greasy) gas ignitor
knob not pressed in long
enough
knob released too quickly
break in power supply
The appliance was discon-
nected from the mains or
there was a temporary
power cut.
the bulb is loose or dama-
ged
ACTION
close the gas by cutting off
valve, close burner knobs,
air the room, take out and
clean the burner, blow on
flame openings
check the household fuse
box; if there is a blown fuse,
replace it with a new one
open the gas supply valve
clean the gas ignitor
hold the knob pressed in
until a full flame appears
around the burner crown
hold the knob down longer at
the "large flame" position
check the household fuse
box, if there is a blown fuse
replace it with a new one
Set the current time
(see 'Use of the program-
mer').
tighten up or replace the
blown bulb (see Chapter
Cleaning and Maintenance)
37